Electrical Fittings
Material: Atkore fittings, unless noted, are made from hot- rolled, pickled and oiled steel plates, strip, bar or coil, and conform to one or more of the following specifications: ASTM A575, A576, A635, A1011 SS GR 33, A1011 HSLAS GR 45 or A36. The fitting steel also meets or exceeds the physical requirements of ASTM A1011 SS GR 33. Maple cable saddles, cable clamps and bus bar clamps are made from kiln-dry maple treated with paraffin to a depth of 1⁄16" (1.6mm). Special sizes of clamps can be fabricated upon request. Cable saddles are fiberglass- reinforced polyester. Channel Raceways: The Atkore Metal Framing System includes an exclusive combination of channel, fittings and hardware listed under new UL classification 5B. This classification covers strut-type channel raceways and fittings for use in accordance with Article 384 of the National Electrical Code, NFPA 70. Included are metal strut-type channel raceways at least .071 inch (1.81mm) thick and metal or non-metal closure strips at least .040 inch (1.02mm) thick. The Atkore system requires no welding, drilling or other complex fabrication techniques. This means faster, easier solutions for virtually any electrical support problem. Atkore channel offers structural and spanning capabilities not available with conventional surface raceway products and is available in continuous lengths of up to 20 feet. Just as important, it is part of an integrated system that can be used for raceways, trapeze hangers, cable-tray supports, lighting grids, fluorescent-fixture supports and countless other electrical applications.
Channel Compatability: All of the electrical components in this section are intended for use with any of the 1 " wide channel. They are not intended for use with 1 " or 13/16" framing systems. Finishes: Components listed in this section are available in: ꞏ Electro-galvanized (EG), conforming to ASTM B633 Type III SC1; ꞏ Hot-dipped galvanized (HG), conforming to ASTM A123 or A153, ꞏ Green Powder Coat (GR), conforming to commercial standards for Powder Coating ꞏ Plain (PL) Note: Many Atkore Metal Framing components, when used with appropriate closures, are UL ® listed, and CSA approved. Design Load: Design load data, where shown, is based on the ultimate strength of the connection with a safety factor of 2.5, unless otherwise noted. Dimensions: Imperial dimensions are illustrated in inches. Metric dimensions are shown in parenthesis or as noted. Unless noted, all metric dimensions are in millimeters and rounded to one decimal place.
Listings:
UL File No. - E19459 UL File No. - E25629 CSA File No. - 013669
Channel & Closure Strips
Fittings
All Products
Made with FlippingBook - professional solution for displaying marketing and sales documents online