Total Algaecide
General Instructions 1. Clean pool thoroughly, brush walls and floor with a stiff pool brush, vacuum to waste and backwash. 2. Adjust the pH to between 6.8 - 7.0. 3. Continue to run circulation and filtration as normal. 4. Superchlorinate the pool using a registered sanitiser. 5. Wait 24 hours and then pour the calculated volume of Total Algaecide near the algae (refer to the table below). DO NOT ADD THE PRODUCT VIA THE POOL SKIMMER! 6. After treatment wait 24 hours, adjust sanitiser levels accordingly and filter as normal.CAUIONREEERNOOSAESNOALGAE cauTion: When dosing the product excessive copper concentrations may discolour hair and swimwear as well as pool surfaces. Please note: This product is NOT compatible with Baquacil polyhexamethylenebiguanide) or similar PHMB products. We recommend using Lo-Chlor Starver® or Starver® X after Superchlorination. This will assist with the removal of phosphate from your pool water, the removal of phosphate prior to adding Total Algaecide improves product efficiency.
dose raTes
POOL VOLUME:
DOSE:A
GALLONS: 5,500 11,000 16,500DRt
LITRES: 25,000 50,000 75,000
Total Algaecide is a concentrated dual action formula which will eliminate stubborn algae. It is very effective against severe blue, green, black spot and mustard algae.LLCCL
550ml 1100ml 1650ml
N.B. Copper in water reduces the activity of chlorine and bromine. Check chlorine or bromine levels 24 hours after applying this product and adjust according to the required levels. Copper concentrations in the swimming pool water must not exceed 1mg/ltr. Check copper levels with a suitable copper test kit. Use algaecides safely. always read the label and product information before use.
Made with FlippingBook Digital Publishing Software