O UTDOOR R ESORT P ALM S PRINGS – R ESTATED A&A R ULES
SECTION 5 – LOT MODIFICATIONS/IMPROVEMENTS
5.A
FIFTH WHEEL ENCLOSURES AND SKIRTS
1. Solid material, such as plywood or T-111, may be used to enclose a 5 th Wheel pin well. Concrete blocks or bricks no thicker than three inches (3”) must be used as a footing for a water barrier between the concrete padand the enclosure. The bottom edge of the siding material must be at least one inch (1”) above the concrete pad. The enclosure must be readily removable and disassembled. Canvas or vinyl fabric may also be used. 2. The forward edge of the pin well enclosure must be positioned no further forward than six inches (6”) in front of the pin hitch unless this location is behind the furthermost protrusion of the front of the fifth wheel, in which case the forward edge of the pin well enclosure may be extended to match the furthermost protrusion of the front of the fifth wheel. The pin well enclosure cannot be wider or higher than the pin well area. 3. Enclosures must have a top vent or vents totaling at least 48 square inches located no less than 12 inches from the top. Enclosures must also have a bottom vent or vents totaling at least 48 square inches located as close to the bottom as possible. 4. Electrical can be run to enclosures but must conform to all current Cathedral City electrical codes and have an approved permit. Refrigerators and Freezers that are installed in conformance to current electrical codes are allowed in the enclosure. All other appliances, including washers and dryers, are prohibited. 5. Skirting under the main body of the RV and to the rear of the pin well may be created using vinyl lattice, Sunbrella (or equivalent) fabric, or vinyl. Fabric or vinyl skirts must be suspended from the RV and weighted at the bottom to rest on the ground. Fabric or vinyl skirting that is supported from the ground on a frame of wood or tubes may not be used, however framing for vinyl lattice is recommended. Solid material, such as plywood, is not allowed. 6. Wheel wells may be covered with lattice with the same materials as the front enclosure, or Sunbrella or similar type fabric. Skirting and wheel well covers must be readily removable. 7. The color of the fifth wheel pin well enclosures, skirting, and wheel well covers must be harmonious with the architectural style and color scheme of the RV using neutral colors compatible with surroundings. No bright colors can be used.
See Exhibit E for Enclosure style allowed.
5.B
STAIRS AND STAIRWAYS
1. Purpose built stairs and stairways must be constructed of a solid material (wrought iron railings are permissible). Materials must be painted or weather resistant composite materials such as Trex. No Engineered hardwood can be used. Completed finish color must be harmonious with the architectural style and color scheme of the RV using neutral colors compatible with surroundings. No bright colors can be used. For more information see Exhibit F attached hereto. 2. Commercially built steel stairs are allowed. 3. Any custom-built stairs or stairways must be approved by the A & A Committee. 4. The footprint of the landing shall be no larger than 20 sq. ft. for safe ingress and egress. The design must be similar to the attached Exhibit F.
5.C
RETAINING WALLS AND SEAT WALLS
1. No wall shall be constructed except for approved retaining walls on perimeter lots. The construction of such a wall requires the following:
10
Made with FlippingBook Ebook Creator