EXHIBIT E
FIF TH W H EEL E NC L O S UR ES A ND S K I RT S
A. Fifth Wheel Enclosures and Skirts
1. Solid material, such as exterior plywood , including , T-111, and rigid plastic or vinyl panels, may be used to enclose a 5th Wheel pin well. Concrete blocks or bricks no thicker than three inches (3 ” ) must be used as a footing for a water barrier between the concrete pad and the enclosure. The bottom edge of the siding material must be at least one inch (1 ” ) above the concrete pad. The enclosure must be readily removable and disassembled. Canvas or vinyl fabric may also be used. 2. The forward edge of the pin well enclosure must be positioned no further forward than six inches (6 ” ) in front of the pin hitch unless this location is behind the furthermost protrusion of the front of the 5th wheel, in which case the forward edge of the pin well enclosure may be extended to match the furthermost protrusion of the front of the 5th wheel. The pin well enclosure cannot be wider or higher than the pin well area. 3. Enclosures must have a top vent or vents totaling at least 48 square inches located no less than 12 inches from the top. Enclosures must also have a bottom vent or vents totaling at least 48 square inches located as close to the bottom as possible. 4. Electrical can be run to enclosures but must conform to all current Cathedral City electrical codes and have an approved permit. Refrigerators and Freezers that are installed in conformance to electrical codes, are allowed in the enclosure; all other appliances are prohibited. Refrigerators and Freezers that are installed in conformance to current electrical codes are allowed in the enclosure. A ll other appliances, including washers and dryers, are prohibited. 5. Skirting under the main body of the RV and to the rear of the pin well may be created using vinyl lattice, of wood or vinyl which has been painted, stained, or otherwise properly colored. Canvas Sunbrella (or equivalent) or vinyl fabric, or vinyl. Fabric or vinyl skirts must be suspended from the RV and weighted at the bottom to rest on the ground. Fabric or vinyl skirting that is supported from the ground on a frame of wood or tubes may not be used, however framing for vinyl lattice is recommended. , properly colored, may also be used. Solid material, such as plywood, is not allowed. 6. Wheel wells may be covered with lattice, or with the same materials as the front enclosure., or Sunbrella or similar type fabric. Skirting and wheel well covers Such enclosures must be readily removable. 7. The color of the 5th wheel pin well enclosures, skirting, and wheel well covers must be harmonious with the architectural style and color scheme of the RV using neutral colors compatible with surroundings. N o bright colors can be used.
Made with FlippingBook Ebook Creator