RESTATEMENT OF A & A RULES - EXECUTIVE SUMMARY
▪ Hedges must be set back a minimum of fifteen feet from the front property line. New and existing hedges within fifteen feet of the front property line are limited to four (4) feet in height. ▪ Hedges cannot impede access to the electrical pedestal ▪ Hedge and plant material cannot create a hazard for vehicle or pedestrian traffic. ▪ I f a hedge abuts natural grass, weed barrier and ground cover shall be installed underneath the hedge and a border must surround the hedge to separate it from the natural grass. Borders must be of masonry material and mortared in place to prevent disruption or movement during landscape maintenance operations. Maintenance of landscaping under and around the hedge is the responsibility of the Owner.
• I. Golf Ball Screens or Netting - this item was completely re-written to the following: o Installation of golf ball screens or netting on a lot requires a permit. Requests for a permit to install golf ball screens or netting must be approved by the A&A Committee. Neighboring owners shall be notified of the Request and given an opportunity to comment before the A&A Committee reviews the Request. o Golf ball screen or netting can be installed only on a lot that is adjacent to the golf course, for the sole purpose of preventing stray golf balls from hitting any itemson that lot. o Must be constructed similar to Exhibit K attached hereto. o Side and center poles must be made from a rigid material. Poles are to be painted the same color as the netting. o Each section of netting or screen may be up to thirteen feet (13’) high and ten feet (10’) wide. No more than two sections can be in place at one time. o Trees or plantings may be required in front of the netting for aesthetic value. No plantings will be allowed to grow on the golf screen. o Any golf ball screens or netting that has been installed and has not been permitted and approved by the A & A Committee must be removed. o Added a new Exhibit (K) with samples of preferred screen or netting.
• J. Outdoor Kitchens/BBQ Backing - minor changes were made as follows:
o Added an additional bullet point to state that: Any appliance installed within the kitchen or adjacent to it is considered part of the outdoor kitchen and cannot exceed 50 inches in height. o Allowed for a minor variance of 2 to 4 inches in length for BBQ backing to accommodate uncut bricks: A two (2) to four (4) inch variance on the length to accommodate uncut bricks and a thickness greater than stated to accommodate décor of Lot may be allowed subject to review and approval by the A&A Committee.
7
Made with FlippingBook Ebook Creator