Lot Number Illumination Rules (5.M.)
1. Illuminated lot number fixtures must be operative throughout the year. Turning off electricity at the meter box when the lot is unoccupied is not allowed. The Association must have access to the meter box at all times; if the meter box is locked, the key must be left with Security. 2. All lot number light fixtures must be on a light sensor-controlled device. This light sensor will be maintained by the Association. 3. The Association is responsible for replacement of light bulbs in lot number light fixtures. The design and construction of replacement and/or modified lot lights must allow easy access to the light bulb. If a modified or replacement lot light does not accommodate light bulbs used by the Association, the owner will be responsible for light bulb replacements. Additionally, if the Association’s employees are not able to easily access the light bulb due to circumstances including but not limited to: heavy weighted caps, plants, pots, or other materials on top of the structure, etc., the owner will be responsible for light bulb replacements for the lot number light. 4 . To improve lot identification for safety and emergency service response: a. When hardscape changes are made to a lot, the Owner must arrange for the lot number light fixture to be relocated as set forth below in 5.b . and replaced if necessary. Owners intending on installing any replacement fixture must apply for a P ermit and be approved by the A&A Committee. b. The lot number light fixture must be on the left side of the lot, viewed from street, no more than six feet (6’) from the street, facing the street and illuminated by a standard 110 volt, 25 watt bulb or the equivalent. All electrical wiring for the light must be connected into the meter box. No low voltage lighting, solar or battery-operated lighting is permitted. The design must allow for easy access to the bulb. c. Approved designs include the original pole, square brick pedestal, or suitable flat - f aced rock. Flat-faced rocks must be pre-approved by the A & A Committee before installation . Only numbers may be used and must br pre-approved by the A & A Committee. Numbers must have sufficient contrast to be visible and legible during the day or night. d. Lot light pedestals must be designed per Exhibit N (attached). Any deviation from allowable design must be approved by the A & A Committee. 5 . Illumination from outdoor lighting shall not unreasonably disturb any Owner’s or tenant’s enjoyment of his or her lot or the common area. Without limiting the foregoing, the following standards are set: a. Sodium and Mercury vapor lamps are prohibited. b. Security lighting shall not be triggered by activities from adjoining properties. c. Any O wner having a lighting grievance may submit a request to the A&A Committee for determination. Any decision by the A&A Committee may be appealed to the Board and the decision of the Board shall be final. Management shall be responsible for enforcement per the Enforcement Procedures
Made with FlippingBook Ebook Creator