INSTALLING PROOFING SYSTEMS
INSTALLING BIRD SPIKE SYSTEMS
Spikes systems are an effective system for proofing against pigeons and gulls in most situations, however this is not recommended for smaller bird species such as Sparrows.
Before installing bird spikes, it is important to make sure the area is cleaned by removing any guano and debris, such as flaking paint this ensures proper adhesion.
Surfaces should be cleaned and sanitised with Biorid to break down the guano and dirt. Ensure the surface is dry before application, for damp conditions use a product such as Fix-all.
Apply silicon to the surface or base of the spike using a caulking gun, use the ridge in the base of the spike as a guide. Immediately position spike onto the surface, press down firmly in to place.
Systems with angled leading spikes offer better edge protection when installed so spikes are protruding over the edge slightly. Rows of spikes should be no further than 65mm apart for pigeons and maximum of 100mm apart for gulls.
Bird spike can be installed by using cable ties for pipes and rails or screwed on to wooden surfaces. They can also be installed on windows and gutters using specific clips.
INSTALLING POST AND WIRE SYSTEMS
Post and wire is a effective method but should only be used in low pressure situations against pigeons and gulls. This system will not work against other pest birds.
Before installing post and wire systems, it is important to make sure the area is cleaned by removing any guano and debris, such as flaking paint this ensures proper adhesion.
Install 90mm posts at maximum intervals of 1.5m. Drill a hole in to the ledge, place a nylon anchor rivet in to the hole and insert a post. Post pads can be used for surfaces that are not suitable for drilling.
Loop plastic coated stainless steel wire through the eye of the post and secure with a crimp.
Insert a spring through the eye of every 4th or 5th post, then loop wire through the eye of the spring and pull taut so that the spring begins to open and secure with a crimp.
Continue this process along the length of the ledge. If more than one row is required install additional rows at a maximum distance of 65mm apart.
172 | BIRD CONTROL
sales@1env.com
+44(0)800 0388 777
Made with FlippingBook flipbook maker