4.4 B ooth A ssembly When assembling booth, leave bolts finger tight until each section is assembled. All flanges should face outward. Install bolts from inside so nut is outside booth. Use a drift pin to align panel holes when two or more panels are difficult to align by hand. Lay out all floor channel for exhaust chamber and walls. As you attach wall panels together, they will also bolt to the floor channel. ^ WARNING Prevent serious injury or death. Most booth components weigh 50-500 lbs. Use adequate lifting devices to raise, move and install booth components.
NOTICE
Prevent equipment damage. Spray booth roof will not support a person. Do not attempt to stand or walk on spray booth roof.
Refer to exploded view drawings included with your spray booth. 1. Starting with exhaust chamber at either rear corner, bolt one corner panel and one rear wall corner panel together. 2. Bolt opposite rear sidewall panel to rear wall panel. 3. Bolt all rear wall panels in place. 4. Bolt tie channel along top edge of rear wall panels. 5. Place exhaust fan panel above side and rear wall panels and bolt in place. 6. Insert filter filler panels between sidewall, roof panels and exhaust chamber. Bolt in place.
CHAMBER SIDE PANEL
FILTER FILLER PANEL
BOOTH SIDE PANEL
7. Following exploded view drawings, continue alternately assembling wall panels and roof panels to each other until you reach front end of booth. Finish off roof section by attaching fire curtain if needed. If booth has front doors, no fire curtain is needed. 8. Verify walls are plumb and booth is square and on floor layout marks. Tighten all mounting hardware. 9. Anchor floor channel to floor at a minimum of every 12 inches. 10. Caulk all panel joints inside the booth with the caulk provided. Do not use a silicone caulk.
Made with FlippingBook - professional solution for displaying marketing and sales documents online