43 D
COOL SMOKE EVAP SMOKE MACHINE
• Voltage: 12V DC • Input Pressure: Max 100 psi • Output Pressure: 12 – 14 in H2O • Safety Pressure Relief: 120 (±5) psi • Auto Shut-off: 5 minutes EVAP DIAGNOSTIC SMOKE MACHINE • Flow Meter: 0 – 0.040 in. • Vapor Output Hose: 10 feet • Pressure Supply: Air/Inert gas/Pump
TURBO/INTAKE DIAGNOSTIC SMOKE MACHINE
Features: • Dual mode leak detection - tests for leaks with or without smoke at the touch of a button • Pressure and vacuum leak diagnostics • Automatic shut-off • Smoke solution with UV enhanced dye • Accessory kit • Powerful 50 watt light • On board storage for adapters and accessories
• Voltage: 12V DC • Flow Meter: 0 – 0.040 in. • Input Pressure: Max 100 psi • Vapor Output Hose: 10 feet • Power Cable: 10 feet • Oil Fill Line Indicator: 3.4 oz.
• Oil Fill Line Indicator: 3.4 oz. • Power Consumption: Max 6.5 Amps
• External Pressure Source: Max 28 psi • Operating Temperature: 0˚ F to 140˚ F • Output Pressure: Internal Pump Max 22 psi
• Power Cable: 10 feet
• Operating Temperature: 0˚ F to 140˚ F (-17˚ C to 60˚ C )
• Safety Pressure Relief: 120 (±5) psi • Power Consumption: Max 6.5 Amps Includes: inflatable intake bladder, full set of block-off caps, exhaust cone, 8 oz. smoke producing fluid and a high intensity smoke illuminating battery powered flashlight.
Includes: full set of block-off caps, exhaust cone, evap schrader valve remover/installer, evap service port adapter hose (green cap), a high intensity smoke illuminating battery powered flashlight and 8 oz. smoke producing fluid.
Includes: UV dye enhanced smoke solution (6.8 oz.), EVAP service port adapter fitting, 50 watt lamp, cap plug set, cone adapter, Schrader removal/installation tool, smoke diffuser MOV-500-0100..........$1,123.69
$863.19 MST-43060EV
MST-43060TB............... $999.95
DUAL EVAP/HIGH PRESSURE DIAGNOSTIC SMOKE MACHINE
COOL SMOKE SMOKE PRODUCING FLUID
6.8 oz. Bottle
• Voltage: 12V DC • Output Pressure: EVAP 12 – 14 in H 2 O
• Input Pressure: Max 100 psi • Safety Pressure Relief: 120 (±5) psi • Auto Shut-off: 5 minutes • Oil Fill Line Indicator: 3.4 oz.
ELECTRICAL DISCONNECT PLIERS MOV-400-1054.........$62.95 Use the hook on the end of the pliers to pull out tab to unlock and then use the point to engage the tab. Squeeze the tabs together and lift to separate the connector from sensor without damage. Allows the technician to use the tool with one hand, and to work on sensors in tight spots. The tool is 8” long and has dual durometer grips for comfort.
Hp internal pump Max 22 psi Hp external pressure source Max 28 psi • Power Consumption: Max 6.5 Amps • Operating Temperature: 0˚ F to 140˚ F (-17˚ C to 60˚ C )
• Flow Meter: 0 – 0.040 in. • Vapor Output Hose: 10 feet • Power Cable: 10 feet
$1,599.95 MST-43065
• Pressure Supply: Air/Inert gas/Pump
Includes: smoke hose, power cord, full set of block-off caps, exhaust cone, evap schrader valve remover/installer, evap service port adapter hose, a high intensity smoke illuminating battery powered flashlight, 8 oz. smoke producing fluid and bladder for intake testing.
DUAL EVAP/HIGH PRESSURE DIAGNOSTIC SMOKE MACHINE WITH TRUCK ADAPTER ACCESSORY KIT
$29.99 LIS-37960
$2,264.29 MST-43070
• Specifications are same as MST-43065
Includes: Same accessories as MST-43065 plus (2) bladders for heavy-duty/truck applications, 6” ring, temperature sensor port adapter, oxygen sensor port adapter and pressure sensor port adapter.
ESI-309A
ESI-192
MTI-FF310
ESI-195
LIS-60150
ESI-193
CIRCUIT TESTERS
ATD-5624
ESI-192
$91.09
Relay Buddy® 12/24 (Tester only)
Settable to 4 and 5 pin relay. Three diagnostic trouble codes. #192 includes the Relay Buddy and a zippered case.
#193 includes (5) relay adapters, (3) adapters for testing shielded relays and (2) adapters for testing new relay types commonly used on fuel pumps and other powered devices. It applies a 7+ amp load to the relay and looks for excessive voltage drop. Test results are displayed by the green, yellow or red LED. #195 can test 10 different 12V relays. Includes three adapters for shielded relays. Large backlit LCD display for visible voltage readings. Checks electrical circuits on all 3–48 volt vehicle systems. Impedance Rating: 200–4000 Ohms. 12 ft. coiled test lead. Ready for use in the new generation of vehicles with mixed or single 24V systems. Internally protected against power surges and over- loads. 8” flexible probe reaches wires in congested places. LEDs show open or short circuit conditions. Trace wires inside bindles, con- duits, behind panels, under carpets, upholstery, etc. Tests 6 and 12V systems. Locates shorts, open circuits and grounds. Use with ignition on. Clip to ground anywhere on vehicle and use probe to make contact with wire or cable being tested. Bulb indicates condition of circuit. Tests circuits from 3 to 28 Volts DC. LED light and buzzer indicator. Does not require a ground wire or clip. Safe for work on automotive computers, ECMs, airbags, etc. Special V-tip allows safe piercing and can be removed to test hard-to-reach places. Operates on replace- able long-life “N” or “LR-1” size alkaline batteries (included). Easily checks 6 and 12V systems. 5 ft. heavy-duty lead. Tough plastic handle lights up if circuit is good. Lead remains flexible in low temperatures. New coil cord design for ease of use. Acetate handle, coiled lead wire. Easily checks 6 and 12V systems. New full size comfortable acetate handle lights up when circuit is good. Leads remain flexible in low temperatures. Ground lead stretches up to 10 ft. Heavy-duty circuit tester for checking low voltage up to 12 volts. By depressing the red button the tester becomes a jumper for powering electrical components or a ground. The probe, handle, cord and clamp are reinforced for durability. Comes with a strain relief spring on the cord. 3–30V detection range of DC voltage. Bi-directional polarity testing: Power and Ground. Dual color LED indicates red for power and green for ground on 6V, 12V and 24V systems. Compact size for use in tight access areas. Computer safe. For use on automotive, com- mercial vehicle and equipment repair. For use on 12V & 42V Hybrid systems. Automatic Voltage Identification: BLUE LED for 12V and RED LED for 42V. Pointed probe tests through wire insulation. Computer and airbag safe. 12 ft. heat and oil resistant coiled cord.
ESI-193
$198.69
Relay Buddy® Pro Test Kit
LIS-32900
ATD-5503
ESI-195
$221.95
Super Relay Buddy® Pro Test Kit
3–48 Volt LCD Wide Range Digital Circuit Tester
ATD-55045
$36.59
FaultFinder Short/Open Circuit Finder & Circuit Tracer
MTI-FF310
$196.69
ATD-5513
Primary Circuit Tester with Ground Clip Cordless Professional Circuit Tester 3–28V
ATD-5500
$10.99
ATD-5500
ATD-5503
$21.69
ATD-55042
ATD-5513
$14.99
Heavy-Duty Circuit Tester
Heavy-Duty Circuit Tester with Coiled Lead Wire
ATD-5624
$16.29
ATD-55033
LIS-32900
$24.69
Heavy-Duty Circuit Tester/Jumper
Heavy-Duty Cordless Circuit Tester 3–30V
ATD-55033
$50.39
ATD-55045
ATD-55042
$26.79
12–42V Hybrid Circuit Tester
Made with FlippingBook flipbook maker