I NSTALLING THE T ABLE S LIDES AND T ABLES
Once the unit and secondary booth are attached together, the table slides and welding tables can be installed into both the secondary booth and the main unit. Place the table slide on the wall of the unit so that the slide channels are horizontal and the channels open to the inside of the booth.
Align the bolt hole pattern on the table slide to the bolt hole pattern on the side wall of the booth.
Fasten the table slide to the wall of the booth using (4) 1/4" - 20 x 1.0" black socket head cap screws, (8) black 1/4" flat washers, (4) black 1/4" lock washers, and (4) black 1/4"-20 nuts. The screw heads should be on the outside of the booth. When a secondary booth is being attached on the side of a main unit, (2) table slides are being attached to a common booth wall. In this situation, each of the (4) bolts must be used to attach both table slides. If the table slide is being installed on the common wall between a main unit and secondary booth, the bolt head can be on either side. Once all the table slides have been attached to the booth walls, insert the table into the channel at the desired height. The table simply slides into the channels of the table slides on both sides of the booth. Make sure the table is being inserted into the same height on
Copyright © Clean Air America, Inc.
Weld Station User Manual, March 2011
Page 36 of 112
Made with FlippingBook Digital Publishing Software