I NSTALLING THE [O PTIONAL ] D UST T RAYS
NOTE:
Dust trays are an optional add on and are not necessary for most operations.
If purchased, there are two dust trays for each main unit. These dust trays must be placed in the filter compartment. As the self cleaning cycle is activated, dust will be blown from the filters and accumulate in the dust tray. See the 'Maintenance' section for proper servicing of the dust trays. Remove the lever handles holding the filter door shut. Make sure to keep the 3/8" flat washers. See the "Installing the Lever Handles" section if necessary.
Swing the filter door open to allow access to the filter compartment.
Slide the first dust tray under the front two filter rings which support the front two filters.
Slide the first dust tray all the way to the left of the filter compartment.
Slide the first dust tray down to the floor of the catch area. It should be sitting below the corner of the slanted panel so that dust is directed into the dust tray.
Slide the second dust tray under the front
Copyright © Clean Air America, Inc.
Weld Station User Manual, March 2011
Page 39 of 112
Made with FlippingBook Digital Publishing Software