C ONNECTING THE S ECONDARY B OOTH L IGHT ( S )
On the main unit, the light(s) are already prewired into the Weld Station electrical panel and ready to go. After determining the configuration of the Secondary Booth (back-to-back or side- by-side), the light for the Secondary Booth must be connected to the unit. If you examine the bottom of the intake, there are (4) oblong cover plates. These plates allow access to a 'T' shaped wire track. Inside the wire track for the main unit is a (2) conductor pin connector. The main unit has a female connector with female pins. Inside the wire track for the secondary booth is a (2) conductor pin connector. The secondary booth has a male connector with male pins. Both connectors will be located behind the right side cover plate. For the main unit, this is located beneath the electrical panel. Find the connectors and run them through the cable track to make a connection. Multiple cover plates may need to be removed to properly run the connector cables.
Copyright © Clean Air America, Inc.
Weld Station User Manual, March 2011
Page 49 of 137
Made with FlippingBook Annual report maker