M OVING THE Dual WeldStation M AIN U NIT
There are various ways to move the Dual WeldStation main unit.
If the Dual WeldStation unit has NOT been uncrated or is still on the pallet, then it can easily be moved by using a fork lift truck. Place the forks under the pallet's main beams and simply lift the unit. Keep in mind, the motor end (top) of the unit is heavier and forks may need to be shifted toward the motor end. If the Dual WeldStation unit has been uncrated, then it can easily be moved by using a fork lift truck. Attach the lifting chains or cables to the fork head ache bar. Attach the other end of the lifting chains or cables to the lifting lugs. The top of the unit can then be lifted using the fork lift truck. Place a wooden '2 x 4 underneath the raised end of the unit. This wood piece will create a gap allowing the forks to be slid under the unit. make sure not to scratch or damage the unit. If the Dual WeldStation unit is uncrated and upright, then the unit can still be moved with a fork lift truck. Place the forks under the unit portion of the main Dual WeldStation unit. Card board or rubber padding can be placed on the forks to prevent scratching of the unit. Make sure the forks are on both side of the light(s) / cables to prevent damaging the lights. Do NOT place the
Page 20
clean-air.com
sales@clean-air.com
1-866-665-1829
Made with FlippingBook. PDF to flipbook with ease