M OVING THE W ELD S TATION M AIN U NIT
There are various ways to move the WeldStation main unit.
If the WeldStation unit has NOT been
uncrated or is still on the pallet, then it can
easily be moved by using a fork lift truck.
Place the forks under the pallet's main
beams and simply lift the unit. Keep in
mind, the motor end (top) of the unit is
heavier and forks may need to be shifted
toward the motor end.
If the WeldStation unit has been uncrated,
then it can easily be moved by using a fork
lift truck. Attach the lifting chains or cables
to the fork head ache bar. Attach the other
end of the lifting chains or cables to the
lifting lugs. The top of the unit can then be
lifted using the fork lift truck. Place a
wooden '2 x 4 underneath the raised end
of the unit. This wood piece will create a
gap allowing the forks to be slid under the
unit. Make sure not to scratch or damage
the unit.
If the WeldStation unit is uncrated and
upright, then the unit can still be moved
with a fork lift truck. Place the forks under
the unit portion of the main WeldStation
unit. Card board or rubber padding can be
placed on the forks to prevent scratching
of the unit. Make sure the forks are on
both side of the light(s) / cables to prevent
damaging the lights. Do NOT place the
forks under the lights. Do NOT let the
forks enter the intake at the back of the
booth area. The WeldStation unit is top heavy and must be prevented from falling backwards
Page 19 of 83
1-866-665-1829
clean-air.com
sales@clean-air.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online