I NSTALLING THE I NTERNAL P ANEL
B AFFLES
The internal spark baffles must be installed before
using the WeldStation. Internal baffles are located
in both the main unit and secondary booth.
1. Begin by tilting the baffle at about a 45
degree angle
2. Slide the baffle into the intake plenum
through the intake opening. Slide it in past
the internal baffle support.
3. Once the baffle is entirely inside the
plenum area, rotate the baffle so that it is
vertical.
4. Then slide the baffle forward in front on
the intake supports.
5. Once the baffle is vertical in front of the
supports, place it flush on the supports
and slide it up so that the bolt pattern on
the baffle is aligned with the bolt pattern
on the baffle supports.
6. Fasten the baffle to the supports inside
the plenum area using (6) 1/4" - 20 x
0.75" zinc plated hex head bolts, (6) 1/4"
zinc plated flat washers, and (6) 1/4" zinc
plated lock washers.
7. Repeat steps 1 through 6 with any other
baffles.
Page 32 of 83
1-866-665-1829
clean-air.com
sales@clean-air.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online