I NSTALLING THE L EVER H ANDLES
For each main unit, there are two lever handles. These
handles must be installed in the filter compartment door
for increased ease of maintenance.
Remove the bolts holding the filter door shut. The
door was bolted shut during shipping to prevent
damage to the lever handles. Make sure to keep
the 3/8" flat washers; however, the 3/8" retaining
bolts can be discarded.
The filter door may swing open allowing access to
the filter compartment.
Swing the filter door closed.
Place a 3/8" zinc flat washer on each of the lever
handles.
Place the threaded stud of the lever handles
through the holes in the filter door arms.
Screw the lock nut onto the back of the lever
handle. This will keep the lever handle attached to
the door during maintenance and prevent the loss
of hardware.
Screw the lever handle into the weld nut and
tighten the door down.
Page 38 of 83
1-866-665-1829
clean-air.com
sales@clean-air.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online