How to replace filters
NOTE:
It is important to ensure that
the filter gaskets seal correctly
for proper operation of the
WeldStation. This will ensure
that you do not get particulate
past the filter compartment.
The easy filter clamping
system of the WeldStation
helps with faster filter
replacement and
maintenance.
1) Press the red 'STOP' button and allow
blower to spin down. This may take several
minutes.
2) Rotate the Disconnect Switch / Emergency
Stop Switch to the '0' or 'OFF' position. This
will disconnect power to the unit to prevent
the unit from being started during the filter
change. Please follow all lock out - tag out
procedures.
3) Shut off the compressed air supply to the
WeldStation.
4) Open the filter door by simply removing the
lever handles. Make sure to retain the
bearing washers so that the washers can be
replaced when finished.
5) Swing the door open to allow access to the
filter compartment and reveal the cartridge
filters.
Page 74 of 83
1-866-665-1829
clean-air.com
sales@clean-air.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online