DRAWBAR & TURNTABLE
33
The adjustable drawbar housing has three grip nuts and two separation bolts. Back off the three grip nuts to release pressure on the slider tube, then further open the housing using the two separation bolts. These actions will allow the housing to open up so the reach tube can slide in the housing. Stand clear of this area during this operation and extend or retract the drawbar in a safe and secure manner. Once the drawbar is appropriately sized, tighten the slider housing by first completely backing off the separation bolts to allow the housing to come together. Next tighten the three grip nuts going from one to another, two or three time until the housing is evenly tightened. Finally, cinch the two separation bolt down so they do not back out. Reinstall the air/electrical connections and secure the safety cable. EXTENDING OR RETRACTING THE DRAWBAR:
Do not lubricate the reach tube or slider housing.
NOTICE
Do not slam the reach into the housing when extending or retracting the drawbar.
NOTICE
www. MACTrailer .com
Made with FlippingBook Annual report maker