98
short form data LED drivers MW 1 - 10V dimming series
Design approved to EN61347 - 2 - 13: particular safety requirements for electronic control gear for LED modules
Description
MW range of 1 - 10V dimmable constant voltage power supply units for 12V LED modules.
High - performance and fully featured weatherproof LED drivers designed for illuminated signage and other lighting applications. Design is approved to EN61347 - 2 - 13: particular safety requirements for electronic control gear for LED modules.
Photo indicative of range
EN61347 - 2 - 13: particular safety require- ments for electronic control gear for LED modules
•
Over - Current Protection
•
Short - Circuit Protection
•
Over - Voltage Protection
•
Over - Temperature Protection
•
SELV output
•
Dust and weather resistant (IP67)
•
5 years limited warranty*
•
An example of a suitable 1 - 10V 1 Gang 2 Way rotary dimmer switch (AU - DSPLED pictured)
Applications For connection to the normal 230V a.c. ‘ Mains ’ supply, these drivers are suitable for 12V current limited LED modules including F - LED, H - LED, M - LED, FlexiLED, PinPoint and SE - LED. Dimming control is via a pair of wires (Blue+, White - ) on the secondary side of the driver. Use a 1 - 10V dimmer switch to adjust brightness. Important: for reliable dimming function observe recommended max. and min. Wattage Note: turning the control to minimum reduces brightness to 10% and does not turn the driver off. Use a ‘ Mains ’ switch in the normal supply ‘ Live ’ for switching the device (and sign) on and off. This is incorpo- rated into some dimmer switches including AU - DSPLED.
Compliance
Meets the requirements of EN61347 - 2 - 13: particular safety requirements for electronic control gear for LED modules
IP67
98
Made with FlippingBook Annual report