Clean Resources - CRP Series Oil-Water Separators - installation instructions
INSTALLATION INSTRUCTIONS
CRP Series
2
CRP 500 — 2000 1. Run the outlet hose to a drain. Do not allow air locks, kinks, or excess coil in the outlet hose. The hose MUST lay flat, or the unit will not drain. 2. Prime the unit by pouring water into the open inlet until water drains through the outlet. Not priming the unit will cause premature failure. 3. Attach the manifold to the top of the unit by inserting the tapered descending port into the small opening of the unit. Align as shown in the photo. 4. Insert the ¼” poly tube from the outlet hub to the push- to-connect fitting on the right side of the timer drain. 5. Required for proper operation: Connect a ¼” poly tube from any clean shop air source to the push-to- connect fitting on the left side of the timer drain. Plug in the timer drain to a 110-volt outlet. 2 -inch) cap(s) as needed. Install and hand tighten ONLY, inlet connectors and condensate lines. 6. Remove the red ( 1 ⁄ 4 -inch) and black ( 1 ⁄ 7. Each unit ships with an antimicrobial pouch to sanitize and inhibit mold and algae growth in the drain hose. Every three months or as needed, unscrew the outlet cap, exchange with a new pouch, and replace the cap.
3
4
5
Life Span* (Months / Hours † )
CRP (CFM)
500
12 / 8,000
750
12 / 8,000
1000
12 / 8,000
1500
12 / 9,000
2000
12 / 8,000
8. Scan the QR code to complete warranty registration.
*Months or Hours, whichever occurs first.
† See complete lifespan chart for details: cleanresources.com/CRPSeries.html
All Clean Resources products comply with the Buy American Act
MAX 175 psi
Additional parts are available from Clean Resources
ü
Avoid damage to couplings. ü
fittings. ü
Check for damage that may have occurred during shipping.
Do not overtighten
COMPLETE WARRANTY REGISTRATION
Questions? Contact your Distributor or Clean Resources: 800-566-0402 • cleanresources.com/contact
v1.8 1-24-2024
Page 1Made with FlippingBook - Share PDF online