Amphenol Socapex │ BACKSHELLS
BACKSHELLS FOR SHIELDING
Assembly instructions for NSA backshells 1 Prepare the cable for termination process and slide onto the cable the items in the order shown on figure 1. 2 Screw the backshell at the rear of the connector. The best performance in time of the system « connector + rear accessory » consists in applying the torque value to screw then to unscrew, to apply the torque value to screw a second time, then to unscrew and finally to screw the torque value a third time. 3 Fold back the braid on the outer jacket and fix it (figure 2) 4 Install the braid as shown on figures 3 and 4: Release the braid and cover the backshell (a) and the connector’s shell. Slide the first ring (b) over the braid. Fold back the braid on the ring (b) and slide the second ring (c) over the braid and the first ring (b). Screw the last ring (d) at the rear of the backshell. If necessary, fix the extra braid on the outer jacket of the cable. If this installation (double folding of the braid) is not possible, refer to figure 5: Slide the first ring (b). Release the braid and cover the backshell (a) and the connector’s shell. Cut the braid as shown. Slide the second ring (c) over the braid and the first ring (b). Screw the last ring at the rear of the backshell. 5 Install the heat-shrink moulded piece.
1
Figure 1
2
3
Figure 2
Figure 3
4
5
Figure 4
Figure 5
Amphenol SOCAPEX
Due to technical progress, all information provided is subject to change without prior notice Designed by Amphenol Socapex
13
Made with FlippingBook - PDF hosting