Catalog Backshells

Amphenol Socapex │ BACKSHELLS

BAND BACKSHELLS FOR SHIELDING

Amphenol designation – Backshells for TV-CTV (MIL-DTL-38999 Series III), SC39 and RNJ LP connectors Series TV SBC 11 14

014

Type of backshell SBC: aluminium right angled band backshell accepting heat shrink moulded piece Size of backshell 09-11-13-15-17-19-21-23-25 (same as connector size) Rear side diameter 10-14-16-20-24-28-32-36 Refer previous page - dimension K Finish

014: olive-drab cadmium plating 023: electroless nickel plating 033K: black zinc nickel plating

Assembly instructions for HE308-35, TV35 and SBC backshells

1 Prepare the cable for termination process (figure 1).

2 Screw the backshell at the rear of the connector.

3 Push the braid over the backshell to the incline point. Milk the braid as required to remove the slack and insure a snug fit around the shield termination area (figure 2).

1

2

Figure 1

Figure 2

4 Prepare the band: Roll the band through the buckle slot twice (the band must be double- coiled). Pull on the band until the mark is within approximately 6.4 mm (.250 in) of the buckle slot (figure 3). The band may be tightened further if desired. 5 Squeeze the gripper release lever of the banding tool and insert the band into the front end opening of the tool as shown on figure 4 (the circular portion of looped band must always face downward). 6 Aligning the band and the tool with the shield termination area, squeeze the black pull-up handle repeatedly using short strokes until it locks against the tool body (this indicates the band is compressed to the tool precalibrated tension).

3

4

Figure 3

Figure 4

7 Complete the clamping process by squeezing the grey cut-off handle.

8 Remove the excess band from the tool.

5

Figure 5

9 Inspect shield termination (figure 5). Il the alignment of the band and the shield in unsatisfactory, tension on the band can be relaxed by pushing on the slotted release lever on the top of the tool. Make adjustments as necessary and squeeze again the black pull- up handle.

Tooling and accessories

Clamping bands Standard band: 072952

Micro band (precoiled): 895693

Caution: Tools and bands should never be lubricated

: RoHS compliant

Amphenol SOCAPEX

Due to technical progress, all information provided is subject to change without prior notice Designed by Amphenol Socapex

17

Made with FlippingBook - PDF hosting