Amphenol • HE7/HE9
14
254 DF / HE901 >>> TOOLING REMOVAL TOOLS
WARNING: a contact extracted must not be used again
49532
49532
- Contact removal tool for receptacles mounted one against the other - Straight PC tails (Y) or solder cup contacts (Z) - Front release 1. Insert the tool in the cavity, between the contact and the edge of the moulding, perpendicular to the mating face ( 1). The tip of the tool should be visible through the window in the moulding (a) 2. Push the tool home, keeping it perpendicular until it contacts the moulding (2) 3. Push the tool right over towards the outer edge of the mounting (2) 4. Pull the tool out, the contact will come with it Part number 049532
- Contact removal tool for receptacles mounted one against the other - Straight PC tails (Y) or solder cup contacts (Z) - Front release
1. Insert the tool in the cavity, between the contact and the edge of the moulding, perpendicular to the mating face (1) . The tip of the tool should be visible through the window in the moulding (a) 2. Push the tool home, keeping it perpendicular until it contacts the moulding (2) 3. Push the tool right over towards the outer edge of the mounting (2) 4. Pull the tool out, the contact will come with it
049532
Part number
20300
- Contact removal tool for receptacles mounted on 15,24 [.600] centres - Straight PC tails (Y) or solder cup contacts (Z) - Front release (3) : Respective position of tool and receptacle 1. Push the tool as for as it will go (4) - The guide (c) abuts the bottom of the moulding - The spigot (a) is opposite the slot (e) 2. Press on part (d) of the tool, the contact tongue is disengaged from its place 3. Cease pressing on part (d) 4. Withdraw tool and the imprisoned contact (5)
020300
Part number
20188
Contact removal tool for receptacles mounted on 12,7 [.500] centres Straight PC tails (Y) or solder cup contacts (Z) Front release
(6): Respective positions of tool and receptacle (guide (c) along the axis of the connector) 1. Push the tool home (7) - The guide (c) goes to the bottom of the moulding - The spigot (a) is opposite the hole (e) 2. Press on part (d) of the tool, in the direction indicated by the arrow (7) . The contact retention is released 3. Release pressure (d)
4. Pull back the tool with contact attached (8) 5. Remove the contact by turning it through 90°
020188
Part number
INSERTION TOOLS
49533
- Contact insertion tool for receptacles - Straight PC tails (Y) or solder cup contacts (Z)
1. Insert the contact into the tool (9) 2. Insert the tool and contact together in the moulding cavity, from the board side, in the position shown on the figure (9)
3. Press the tool right home. The contact tongue positions itself in its slot (10) 4. Withdraw tool. The contact held by the tongue should remain in recess
049533
Part number
All dimensions are given for information only and are in mm [inch], except as otherwise specified
Made with FlippingBook - professional solution for displaying marketing and sales documents online