Amphenol Socapex │ 2M MICRO MINIATURE │ Technical Characteristics
TECHNICAL CHARACTERISTICS
Materials characteristics
Operating temperature (C°) Min
Salt Spray exposure per EIA 364-26
Shell Material
Shell finish
Max
48
Electroless Nickel
Olive Drab Cadmium
Aluminum
-65
+150
Black Zinc Nickel Durmalon (Ni-PTFE)
500
: RoHS compliant
Mechanical characteristics
Characteristics
Performance
Procedure
Durability
500 mating cycles
EIA-364-09
EIA-364-27 Condition D 300 G, halfsine, 3ms, 3 axes
Shock
300 G ± 15
EIA-364-28 Test Condition V Letter I 100 milliamp test current 50- 2,000 Hz @ temp. MIL-STD-202 Method 204, test Condition G 12 sweep cycles per axes, 20 min. per 10-2000-10Hz @ temp.
Random vibrations
43,9 g RMS
Sine vibrations
60 g RMS
Environmental characteristics
Characteristics
Requirement
Procedure
EIA-364-31 Condition B Method III 80-98% RH 10 cycles (10 days) +25° C to +65° C
No deterioration which will adversely affect the connector. 100 Mohms minimum insulation resistance during the final cycle. Following the recovery period, connectors shall meet contact resis - tance, shell-to-shell resistance and DWV requirements. No evidence of moisture on connector interface or contacts. Connector shall meet dielectric withstanding voltage. No visible damage from immersion in various fuels and oils. Connector shall meet coupling torque and dielectric withstanding voltage requirements.
Humidity
Step 7b vibration deleted. 24 hour recovery period.
Altitude immersion
EIA-364-03
EIA-364-10 Unmated connectors
Fluid Immersion
MIL-STD-810F Method 512.4 1 meter immersion 1 hour
No evidence of water penetration into mated connectors. ≥100Ω insulation resistance.
Water immersion, mated
Connectors with waterblock potting process. 1 X 10-4 cc/second maximum helium leak rate at 1 atmosphere pressure differential following thermal shock conditioning.
EIA-365-02 3 cycles thermal shock -57°C to +71°C 75 min. dwell 5 minute transfer rate
Water immersion, open face sealed receptacle with non- removable PC tails or solder cup contacts
EIA-364-32 Test Condition IV 5 cycles consisting of -65° C 30 minutes, +25° C 5 minutes max., +150° C 30 minutes, +25° C 5 minutes max.
No mechanical damage or loosening of parts. Following thermal shock, connector shall meet contact resistance, DWV, insulation resistance and shell-to-shell resistance requirements.
Thermal shock
Mated connectors shall withstand the effects of blowing sand and dust
Sand and dust
MIL-STD-810F, Method 510.4
All dimensions are given for information only and are in mm
Amphenol SOCAPEX
Due to technical modifications, all information provided is subject to change without prior notice Designed by Amphenol Socapex
14
Made with FlippingBook interactive PDF creator