Vehicle Driving
or deceleration, etc. The inclination of the low beam can be adjusted through the lighting interface on the central control display. Adjust it higher, and the low beam shines farther. Adjust it lower, and the low beam shines closer.
Light Control Handle
Lane change light: Move the light control handle one gear upward/downward, turn on the right/left lane change lights, and the corresponding turn signal lamp will flash 3 times and then go out; Turn signal lamp: Move the light control handle two gears upward/downward, turn on the right/left turn signal lamp, and the corresponding turn signal lamp will flash. Turn signal lamp can be turned off by moving the light control handle to the previous gear or the next gear or returning steering wheel to its original position;
High beam: After turning on low beam, push the light control handle forward and the vehicle will switch from low beam to high beam. Move the light control handle forward again and the vehicle switches back low beam; Overtaking light: Move the light control handle backward, high beam will light up, and they will go out when you release them.
Daytime Driving Light
When the vehicle is powered on, the daytime running lights will be automatically switched on if the position lights are not on.
Front Automatic Beam (HMA)
The Front Automatic Beam (HMA) function shares the same camera with the Lane Assistant System (LAS). When the system detects tail lamp of the vehicle ahead, the headlights of the oncoming vehicle, or high ambient light, it automatically suppresses the high beam (i.e. turns off high beam). When the ambient light becomes dim and there is no vehicle ahead, the suppression is lifted and high beam resumes lighting.
Warning
HMA is an auxiliary function and can’t guarantee that it is applicable to all driving situations. You
104
Made with FlippingBook - Online catalogs