Maintenance and Self - service
while paying attention to traffic conditions to restore full braking effect.
When cleaning the inside of the rear window, soak a soft cloth slightly with water and gently wipe the window in a direction parallel to the heating wire or antenna. Be careful not to scratch or damage the heating wire or antenna. When waxing the body, make sure to remove the wax from the windshield. To avoid damage, matt painted parts, plastic parts, headlamp glasses and tail lamps must not be waxed or polished. During the rainy season, check the sand and dust on the glass sealing strips and wipe them off in time.
CAUTION
• Do not wash or wax the vehicle while the motor is running.
• Before washing your vehicle, check that the charging port cover is properly closed.
• When cleaning your vehicle, never use the following items:
1. Dry cloth, rough cloth or hard cloth;
2. Excessively hard cleaning tools;
3. Abrasive cleaners;
4. Solvents or cleaning agents containing solvents.
• Do not polish the vehicle if it is dirty or in a dusty environment.
• Never use glass cleaner to clean the inside surface of glass where the window defogger heater wire or antenna is located. • The grease used for sunroof sealing is: DuPont XP1A6; Guide rail grease: Natto Dowsyn2602. • Never use "tire self - cleaning agent", "all - purpose self - cleaning agent" or other similar corrosive cleaning agents to clean the front and rear bumpers and panels outside the doors to avoid corrosion and discoloration.
Automatic vehicle wash
It is preferred to use a vehicle wash without brushes, and pay attention to the height and width of the model that the vehicle wash is suitable for. Close all doors, windows and glass sunroof, lock cylinder cover and trunk lid/ back door, and fold exterior rearview mirrors.
Do not choose hot wax for vehicles equipped with decorative and protective films.
High Pressure Cleaner
The temperature of the cleaning water should be below 60 ℃ .
Keep the water gun nozzle at least 40cm above the vehicle and spray evenly.
Sensors, camera trims and protective films can only be sprayed directly for a short time, and the water pressure must not exceed 100 bar.
170
Made with FlippingBook - professional solution for displaying marketing and sales documents online