ENGLISH
2.2.2.4 CROSSHEAD SPEED DURING A TEST During crosshead movement, the DRO will display the current velocity of the crosshead. If manually operating the crosshead using the jog keys, the DRO will display the crosshead velocity for your jog movement. When you press and hold a jog button, the crosshead will ramp up to the maximum allowed speed you have setup in the MOTIONS setting. The maximum crosshead velocity for an FMM Test Frame is 40 inches per minute (1016 mm/min). 2.2.2.5 RESULTS AFTER A TEST IS COMPLETED The measured results at the completion of a test are displayed in the Results window. Results, also called coefficients, are displayed in large, easy-to-read text with labels. If tolerances are used, a result that is
2.2.2.2 LOAD BARGRAPH The Load Bargraph displays the measured load in a graphical format. The bargraph fills from the center (zero) position. Tensile loads fill the bargraph from the center upward, while compressive loads fill the bargraph from the center downward. The bargraph uses color to indicate the percentage of load being applied to the load cell sensor relative to the sensor's rated load capacity. The bargraph will display green when the measured load is 0 to 75% of the sensor's rated capacity. The bargraph will display yellow when the measured load is 76% to 90%. The bargraph displays red when the measured load is over 90%. Caution should be exercised when the bargraph is displaying yellow. This indicates that you are operating at the upper range of the load sensor, which is perfectly acceptable. The red color indicates that you are operating at the extreme high end of the sensor's capacity. You should exercise extreme caution in order to not overload the load cell sensor.
"outside the tolerance" displays in red text. 2.2.2.6 TEST STATUS DURING A TEST
During an active test, the bottom Results window displays the current test status. With Cyclic and Hold tests, a cycle counter or countdown timer is displayed.
Load status on BLC Sensor Green is safe operating area
2.2.2.3 ACTIVE DISTANCE The "D" symbol displays the crosshead travel when the crosshead is moving or where the crosshead stopped relative to the Home position. Selecting the "D" symbol will zero the distance. NOTE 1. Distance is relative to the Home position you establish.
2. Distance values may use "in" (inches) or "mm" (millimeters). 3. During an active test method, do not press the "D" target.
Shows Dwell/Hold Time target and elapsed time remaining
PKG08807 - UML1 13
Made with FlippingBook - professional solution for displaying marketing and sales documents online