ENGLISH
17.1.3.4 RESULTS SECTION The Results section displays your results for your selected coefficients. This section displays the value and units of measure for each selected coefficient. If tolerances are used, results that are "outside" the tolerance, display in RED to indicate a "failed" result. The Results section also displays the Runs List. Each Run is numerically listed. You may select the Run number to view the results for that particular Run.
When the Graph view is being used, the Overlay function can be used to overlay traces for up to five (5) Runs on a single graph for comparison purposes. The Result section also displays the test status in the Status Block. During runtime, the Status Block will indicate the step being performed and the currrent status of the test.
During an active RUN, the Limit setpoint is displayed. In this example the tension load limit of 38N is shows above the currently measured load of 14.130N.
The Overlay target is used during the Graph View. This allows you to select multiple RUNS for graphing together. The Runs List shows the current number of Runs performed. In this example, we are running Run 2. Run 1 is listed.
The Data View shows the results from the previous test RUN (Run 1).
The Status Block reports the current step being performed for the test setup. Shown is the test direction (tension/pull), the Load Limit (38.000N) and the Test Speed (20.000 in/min). The Step Number (2) is also displayed.
This symbol represents the Data View. It is highlighted to show that you are viewing the Data View format. The other symbol represents the Graph View. You may also perform a test Run while in the Graph View.
PKG08819-UML2SOFT 49
Made with FlippingBook - professional solution for displaying marketing and sales documents online