TransGas Comprehensive Tariff
(e) The Customer and TransGas agree to the implementation of Low Intervention Trade Transactions in accordance with G-14 and either the Customer or TransGas has the right to request a revocation of the conditional permission for Low Intervention Trade Transactions in accordance with G-14. 6.4 Check Measuring Equipment All related equipment, appliances and buildings shall be installed, maintained and operated, or furnished by TransGas. Customer may install and operate or may cause its supplier to install and operate measuring and testing equipment, which shall not interfere with the operation of the Gas Transmission System or Storage Facilities. 6.5 Verification The accuracy of TransGas' measuring and testing equipment shall be verified in accordance with the Act and Regulations referred to in Clause 6.3 herein. 6.6 Requests for Testing TransGas and/or the Customer may request testing of the accuracy of the measuring and testing equipment. Notice of the time and nature of each test to be conducted at the point of measurement shall be given by TransGas to Customer sufficiently in advance to permit Customer's representative to be present. Tests and adjustments shall be made in the presence of and observed by representatives of both TransGas and Customer. All tests of such measuring and testing equipment shall be made at TransGas' expense, except that Customer shall bear the expense of tests made at Customer’s request if the inaccuracy in the measurement of the amount of Gas or Heating Value of the Gas is less than the amount specified in Clause 6.7(a) hereof. If at any time any of the measuring or testing equipment is found to be out of service or registering inaccurately, it shall be adjusted at once to read as accurately as possible. The amount of Gas or Heating Value of the Gas desired to be measured or tested during the period in which such equipment was registering inaccurately or was out of service shall be estimated by: (a) using the data recorded by any check measuring equipment installed and accurately registering, or (b) if such check measuring equipment is not installed or is not registering accurately, by correcting the error by calibration tests or mathematical calculations, or (c) if the methods provided in Clause 6.6(a) and (b) cannot be used, by estimations based upon deliveries under similar conditions during the period in which the equipment was registering accurately. 6.7 Correction of Measurement Error If the period in which such equipment was registering inaccurately or was out of service is not known or agreed upon it shall be deemed to have been registering inaccurately or out of service for a period of one-half (1/2) of the elapsed time since the last test.
Page 41
Business Practices Overview 1.2 General Terms and Conditions
Made with FlippingBook Ebook Creator