ZERO-POINTS Pneumatic Clamping Module without clamp assist / Single Acting
Pull-in/ locking force up to [kN]
Holding force [kN]
Model No.
Size
Blow out
Pneumatic opening. Pneumatic blow-out. Opening operating pressure: KP10.3 min. 5 bar - max. 12 bar. KP20.3 min. 4.5 bar - max. 12 bar. Cover and piston hardened. Repeat accuracy < 0.005 mm. (Studs Sold Separately)
● ●
570258 KP10.3 570259 KP20.3
10.0 17.0
25 55
Application: Zero-Point Clamping System for set-up-time-optimised clamping during cutting and non-cutting machining. Note: The pneumatic clamping module, single acting has high holding, pull-in and locking forces. This is opened pneumatically (1) and mechanically locked through spring force. Subsequent uncoupling of the pressure lines is possible at all times (Hydraulic Module clamps without clamp assist, Single Acting). The clamping module with blow-out and support control has two connections: 1x pneum. opening (1), 1x pneum. blow-out and support control (3), 1x vent (5). (The pneumatic blow-out and support control can optionally be connected.) Dimensions:
Model No.
dia.D [mm]
dia.DN [mm]
dia.D1 [mm]
H [mm]
HA [mm]
dia.LK [mm]
T [mm]
Size
M
570258 KP10.3 112 22 78.0 35 10 88 M6 25 570259 KP20.3 138 32 102.0 49 15 115 M6 34
KP20.3
KP10.3
INTERNAL BLOW-OUT
BLOW-OFF/SUPPORT CONTROL
DIRT AND CHIPS IN THE CLAMPING MODULE? Using compressed air for cleaning removes dirt and debris from the inside while also providing workpiece support control through a differential pressure sensor.
IS A WORKPIECE SEATED WITHOUT GAP OR NOT? The blow-out function with compressed air cleans the support surfaces and can also be used for workpiece support control through a differential pressure sensor.
Utilize our CAD Library online at Vektek.com for cavity drawings
47
Made with FlippingBook - Online Brochure Maker