AutoBody Master

Etch Fill Etch Fill provides the convenience of a self etching corrosion resistant precoat primer with moderate filling properties. Etch Fill offers excellent adhesion to bare steel, aluminum, galvanized, & zinc coated substrates. Etch Fill etches into the substrate and fills minor imperfections. Etch Fill can be topcoated with additional primers, sealers or topcoat directly with color. Product color: Mauve/Rose

Part # 8466 8467 8166 8167

Description

Size

Etch Fill Primer Etch Fill Primer Etch Fill Catalyst Etch Fill Catalyst

Gallon Quart Gallon Quart

Substrates • Fully cured finishes - Sand with 240 - 320 grit paper • Steel, Galvanized & Aluminum - Sand with 80 - 180 grit paper • Always clean surface prior to application with 5900 or 5911 wax & grease remover. Mixing

1 Part Etch Fill Primer 1 Part Etch Fill Catalyst Set Up Tech Info Tip/Needle: Spot Air Pressure:

1.3mm to 1.5mm

Conventional 35 - 45 psi / HVLP 5 to 10 psi at cap Overall Air Pressure: Conventional 45 - 55 psi / HVLP 5 to 10 psi at cap Viscosity (#2 Zahn) 18-20 seconds Film Build: 2-3 mils DFT Coverage: 205 sq. ft. @ 1 mil Application Apply 1 to 2 full wet coats to provide excellent adhesion, corrosion resistance, and fill minor imperfections. Allow 5 to 10 minutes between coats. Drying Sand Time Sanding not recommended Recoat 30 minutes cure time before recoating with primer or sealer, recoat within 24 hours Topcoat 1-2 hours minimum, sealing is recommended. See Master Tips. Pot Life 24 hours - Product should be stored in plastic container Physical Data Volume Solids RTS: 12.8% VOC RTS: 5.3 lb./gallon Humidity Resistance: Excellent Salt Spray Test: Excellent Master Tips Heavier coats should be allowed additional cure time before the application of additional primers, sealers or topcoats. As a general rule, allow 1 hour per wet coat before topcoating direct with color. Sealing is recommended because if not fully cured, Etch Fill can “yellow” topcoat color. If allowed to cure longer than 24 hours, scuff sand before recoating or topcoating. Do not tint.

Page 22

Made with FlippingBook flipbook maker