AutoBody Master

Epoxy Primer An outstanding quality, two component, isocyanate, lead, and chromate free epoxy primer and sealer with good corrosion resistance. Offers excellent adhesion to prepared metal, fiberglass and aluminum surfaces.

Description

Size

Part # 8411 8412 8413 8414 8416 8121 8122

Epoxy Primer Green/Gray Epoxy Primer Green/Gray Epoxy Primer Black Epoxy Primer Black Epoxy Primer White

Gallon Quart Gallon Quart Quart Quart

Epoxy Catalyst Epoxy Catalyst

Half Pint

Substrates • Fully Cured Finishes - Sand with 240-320 grit paper • Steel, Galvanized& Aluminum - Sand with 80-180 grit paper • Fiberglass and SMC - Sand with 150-240 grit paper • Always clean surface prior to application with 5900 or 5911 wax & grease remover. Mixing VOC Compliant Primer Conventional Primer Conventional Sealer 4 parts Epoxy Primer 4 Primer 4 Primer 1 part Epoxy Catalyst 1 Catalyst 1 Catalyst Up to 1/2 Part Urethane Reducer 3 Urethane Reducer 4 Urethane Reducer 5 Min. Mechanical Induction 5 Min. Mechanical Induction 5 Min. Mechanical Induction Set Up Tech Info Tip/Needle: 1.5mm to 1.8mm Spot Air Pressure 35 - 45 psi / HVLP 5 to 10 psi at cap Overall Air Pressure: 45 - 55 psi / HVLP 5 to 10 psi at cap VOC Primer Conv. Primer Conv. Sealer Viscosity (#2 Zahn) 20-25 Sec 19-22 Sec 16-18 Sec Film Build 1.0-1.2 mils DTF .8-1.0 mils DTF .5 mils DTF Coverage (@ 1mil) 481 Sq. Ft. 336 Sq. Ft. 288 Sq. Ft. Application VOC Compliant Primer Conventional Primer Conventional Sealer 1 full wet coat 1-2 full wet coats 1 wet coat w/10-15 min. flash Drying VOC Primer Conv. Primer Conv. Sealer Sand Time Not recommended 60 minutes Not recommended Recoat 60 minutes 60 minutes 30 minutes Topcoat 60 minutes 60 minutes 30 minutes Pot Life 8 hours 8 hours 8 hours

Physical Data Volume Solids RTS Humidity Resistance Salt Spray Resistance VOC RTS

30%

21%

18%

4.8 lb/gal. Excellent Excellent

5.5 lb/gal. Excellent Excellent

5.7 lb/gal. Excellent Excellent

Master Tips Do not use over lacquer products. Recoat within 72 hours. Greater than 72 hours, scuff sand before top coat. In temperatures over 77°F recoat within 36 hours.

Page 23

Made with FlippingBook flipbook maker