Equipment & Implement Enamels Gallon Aerosol Color 6455G 6455 Allis Chalmers Orange 6401G 6401 Black-Gloss 6412G 6412 Black-Low Gloss 6499G 6499 Caterpillar Yellow-New 6487G 6487 Caterpillar Yellow (Old, light) 6435G 6435 Ford Blue 6409G 6409 Ford Gray 6400G 6400 Gray Primer 6431G 6431 Harvester Red 6443G 6443 John Deere Green 6461G 6461 John Deere Yellow 6471G 6471 Massey Ferguson Red 6402G 6402 Red Oxide Primer 6406G 6406 Silver Aluminum 6463G 6463 School Bus Yellow 6476G 6476 White Gloss
Substrates • Fully cured finishes - Sand with 240 - 320 grit paper • Steel - Sand with 80 - 180 grit & prime with Equipment & Implement Primer Mixing
• Reduction is not required. If reduction is preferred, reduce with VM&P Naphtha #5960-1 or 5960-4 (for spray applications) or Mineral Spirits #5950-1 (for brushing or rolling applications) at a 16:1 ratio. Set Up Tech Tip/Needle: 1.4mm to 1.6mm Spot Air Pressure: 35 - 45 psi / HVLP 5 to 10 psi at cap Overall Air Pressure: 45 - 55 psi / HVLP 5 to 10 psi at cap Coverage 500 sq ft /gallon @ 1 mil Application Product can be rolled, brushed, airless or compressed air sprayed. Apply 2 - 3 coats until sufficient coverage or hiding is achieved. Allow each coat to become hand slick before additional coats are applied. Drying
Dries to the touch in 4 to 6 hours. Pot Life: Indefinite if sealed Physical Data VOC RTS
< 3.5 lb./gallon
Humidity Resistance
Very good Very good
Salt Spray Test
Master Tips Do not apply in direct, hot sunlight. Surface & air temperature should be between 40-90°F during application and dry time. Catalyzation is not recommended.
Page 1
Made with FlippingBook flipbook maker