ShadeSystem 2K Sealer ShadeSystem 2K Sealer is a super productive primer sealer that offers a variable gray shade intermix system, excellent flow and leveling, excellent color holdout and medium build to fill many small surface imperfections. Sealer can be topcoated 15-30 minutes after application, nib sanded after 20-30 minutes if needed.
Part # Description
Size
8321 8322 8324 8325 8327 8328 8124 8125 8126 8127
S1 ShadeSystem 2K Sealer White S1 ShadeSystem 2K Sealer White S4 ShadeSystem 2K Sealer Gray S4 ShadeSystem 2K Sealer Gray S7 ShadeSystem 2K Sealer Black S7 ShadeSystem 2K Sealer Black ShadeSystem Sealer Activator ShadeSystem Sealer Activator Slow ShadeSystem Sealer Activator
Gallon Quart Gallon Quart Gallon Quart Quart 1/2 Pint
Quart
Slow ShadeSystem Sealer Activator 1/2 Pint Substrates Fully Cured Finishes: Finish sand with 400-600 grit paper. Steel, Galvanized & Aluminum: Pre Coat with Super Etch or Etch Fill Self Etching Primer Fiberglass & SMC: Finish sand with 400-600 grit paper Mixing 4 Parts Sealer 1 Part Activator S1 S2 S3 S4 S5 S6
S7
Recommended Shade:
No Mix No Mix 8321/8322 1 part S4 2 parts S4 8324/8325 1 part S7 2 parts S7 8327/8328 Whites Lt Red Med Red Med Dk Red Dk Red Dk Red Black Lt Yellow Lt Green Med Green Med Dk Green Dk Green Dk Green Very Dk Red Silvers Lt Blue Med Blue Med Dk Blue Dk Blue Dk Blue Very Dk Green Lt Brown Med Brown Med Dk Brown Dk Brown Dk Brown Very Dk Blue Med Yellow Med Dk Silver Charcoal Silver Dk Charcoal Silver Very Dk Brown 2 parts S1 1 part S1 No Mix 2 part S4 1 part S4
Color Type:
Set Up Tech Info Tip/Needle: Spot Air Pressure: Overall Air Pressure:
1.3mm to 1.5mm
35 - 45 psi / HVLP 5 to 10 psi at cap 45 - 55 psi / HVLP 5 to 10 psi at cap
Film Build:
1-1.5 mils / full wet coat
Coverage (@ 1 mil)
548 sq. ft. @ 1 mil
Application Apply 1 medium wet coat using 35-45 psi at the gun. Allow 15-30 min. flash before topcoating.
Drying Topcoat Recoat
15-30 minutes 30 minutes 20-30 minutes
Sand Time
Physical Data Volume Solids RTS
34.1% 2 hours
Pot Life: VOC RTS:
4.6 lbs/gallon
Master Tips Film build, temperature, and humidity will affect dry times. Do not use accelerator or fish eye eliminator in this product. Make sure you’re ready to apply topcoat before using this sealer. If not topcoated within 40 minutes, you must scuff and re-apply before topcoating.
Page 28
Made with FlippingBook flipbook maker