AutoBody Master

Hi Solids Clear Hi Solids Clear is a 4.2 VOC Urethane Clear that exhibits superior flow, excellent gloss retention and depth. Its high solid content offers exceptional coverage & depth with only 2 coats. Part # Description Size 8990 Hi Solids Clear Gallon 8994 Hi Solids Clear Quart 8195 Hi Solids Clear Catalyst #5 Quart 8196 Hi Solids Clear Catalyst #6 Quart 8193 Hi Solids Clear Catalyst #5 1/2 Pint

Substrates Apply over basecoats, catalyzed enamels or urethanes. Follow basecoat mfg prep recommendations. Mixing 2 part Hi Solids Clear 1 part Urethane Catalyst Up to 10% urethane reducer can be added if desired. Set Up Tech Info Tip/Needle: 1.3mm to 1.5mm Spot Air Pressure:

35 - 45 psi / HVLP 5 to 10 psi at cap 45 - 55 psi / HVLP 5 to 10 psi at cap

Overall Air Pressure: Viscosity: #2 Zahn

20-25 seconds

Film Build: Coverage

2 - 3 mils

651 sq. ft. @ 1 mil

Application Apply 1 medium wet coat followed by a full wet coat. 10-15 minutes flash between coats. Drying Air Dry w/8195 Spot & Panel w/8196 Overall Dust Free 15-20 min 15-20 min Tack Free 30-45 min 30-45 min Sand Time 16-24 hours 16-24 hours Recoat Overnight Overnight Pot Life 3-5 hours 3-5 hours Force Dry - Purge for 15 to 20 minutes, 40 minutes at 140° F. Sand 1 hour 1 hour Recoat 4 hours 4 hours Buffing If necessary, sand with 1500 or finer grit paper after 16 hours. Buff with appropriate compound after 24 hours. Buffing is easiest when done within the first 48 hours following application.

Physical Data Volume Solids RTS

43%

Pot Life: VOC RTS:

5 hours

4.2 lb./gallon

Humidity Resistance:

Excellent Excellent

Salt Spray Test:

Master Tips If problem occurs during application, painter must get a minimum of 2 coats on vehicle before stopping for repair or additional recoat. Allow to dry overnight, then scuff before primer, color or clear application. Retard in extreme heat or humidity. Accelerate in shop temps below 70°F.

Page 33

Made with FlippingBook flipbook maker