Drag Racing Parts & Accessories

Sealed Battery Box MOR74051 Lightweight, black polyeth- ylene battery box, ideal for locating the battery to the trunk, is completely sealed to prevent spills or gases from entering the driver compartment. Box will secure a Series 24 battery and is 10-1/2" deep, 13" wide and 9-1/2" tall. In- cludes mounting hardware. Battery cable not included. Battery Cable Kit MOR74005 Battery cable kit will withstand the high amperage needed to start high performance racing engines. Includes 20' of 2 gauge copper cable with four terminal ends. Battery Cable Remote Fitting End Kit MOR74170 Quality, screw-together battery cable ends for side post batteries are ideal for splicing in battery disconnects, remote jumper terminals or junction blocks. Two per package. Battery Post Boots MOR74114 Molded plastic boots prevent accidental shorts and fit over most Battery Post Terminal End Kit MOR74175 Same as MOR74170 except for top post batteries. Two per package. Battery Quick Connect Plugs Quickly connect vehicle’s electrical system to a battery charger, generator, etc. Tough polycar- bonate plugs have spring-loaded copper contacts. Part No. Description MOR74200 Battery Quick Connect Plug

Remote Battery Jumper Terminals MOR74140 Place the battery anywhere in the

car and it will still be accessi- ble between races for charging with remote jumper terminals.

Terminals can be positioned in the most convenient spot, inside or outside of the car, and connected to the battery with a high amper- age cable such as the Moroso MOR74005. Universal for 6-36 Volt systems. Two per package. Thru Panel Battery Connector

Used wherever a battery cable, or other large diameter, high amperage cable, passes through a firewall or similar panel. Fits through 1-1/4"

hole and is held solidly by included spanner kit. Use MOR74170 Battery Cable Remote Fitting End Kit to complete installation. Part No. Description MOR74144 Red Thru Panel Battery Connector MOR74145 Black Thru Panel Battery Connector

Starter Heat Shields Excessive heat not only cuts short the life of a starter, but also reduces the starter’s cranking

power. Starter heat shields provide protection from heat on race cars and tow vehicles. Made of high temperature insulating material sandwiched between two sheets of aluminum. Part No. Description MOR74299 Fits SBC/BBC With Tilton Starter MOR74300 Fits SBC/BBC With Delco Starter Battery Disconnect Switches A battery disconnect switch is one

of the most critical safety devices in a race car. Turning the non-slip handle cuts power to all electrical devices including ignition. Part No. Description MOR74100

non-disconnect top terminals. Compatible with 4 gauge and smaller cable. Boots may be folded back for battery post access when charging, etc. Includes (1) red and (1) black boot.

For Cars Without Alternator

MOR74101 For Cars With Alternator MOR74110 Protective Boots For Terminals, (1) Red And (1) Black Super-Duty Battery Disconnect Switch MOR74102

Super-duty switch includes two pairs of copper studs for shutting down the entire electrical system. Useful when

race car is fitted with an alternator. Rated at 2,000 amps intermittent and 300 amps continuous. Includes face plate and on/off decal. Push/Pull Battery Disconnect Mounting Kit MOR74105

Mount to the roll cage to actuate the battery disconnect switch. 18"

MOR74201

Battery Mini Quick Connect Plug

long black anodized link, equipped with a T-handle, passes thru the rear panel to engage switch. Includes brackets, linkage, bush- ings, link and fasteners. Use with MOR74100 or 74101 Battery Disconnect Switches.

454

Made with FlippingBook flipbook maker