OPERATIONAL CONTROLS
Warning Alarm (B) The warning alarm works with the information clus- ter gauge to alert the operator to problems. When a condition activates a warning light on the gauge, the warning alarm also activates and sounds a continu- ous signal alarm to alert the operator. If the warning alarm sounds, check the lights on the information gauge to determine the cause of the warning alarm and then take appropriate action.
High/Low Shift Lever (E)
ATTENTION The high/low range shift lever shifts both the front and rear transaxles simultaneously. Occasionally, the engagement of the transaxle gears is prevented by misalignment. Moving the steering wheel slightly to the right or left will move the gears enough to complete the engagement. CAUTION Never shift while under load, while moving, or while on a slope. Always ensure the shift lever is secured in the lock position at the end of each shift stroke. Always install the ball pin to prevent the shift lever from accidentally moving to the neutral position. With the power unit parked on level ground,
Ignition Switch (C) 1. Off or Stop Position - all 12 volt power going through the ignition switch is off. 2. On or Run Position - en- gine run position, 12 volt power is sent to acces- sories. 3. Start Position - when the key is turned to the start position, the starter will engage.
1
2
3
remove the ball pin (A) and push the shift lever forward to select low range (1). Move the shift lever to the middle of the shift stroke to place the transaxle gears in neutral (0). Pull the shift lever back toward the opera- tor to select high range (2).
1
0
Throttle Lever (D) Moving the throttle lever forward toward the fast position (1) increases the engine Revolutions Per Minute (RPM). Moving the throttle lever backward toward the slow position (2) decreases the engine RPM.
1
Ensure the shift lever is secured in the lock position at the end of the shift stroke. Reinstall the
2
2
ball pin (A) into the shift select bracket position at the same end as the shift lever, in order to prevent the shift lever from being accidentally disengaged.
A
Operation - 25
Made with FlippingBook - Online Brochure Maker