GENERAL OPERATION
Menu Options To calibrate the slope gauge, change audible or visual alert set-points, or to change the display screen, hold your thumb over the slope gauge sensor for eight seconds to enter the options menu. The option screens A will display instructions for making changes to the current feature. Swipe up across the sensor to cycle through the menu screens. Each swipe advances one
Display Screen 1 is the factory default screen and it displays the total slope angle in degrees.
Display Screen 2 displays the total slope angle in degrees, along with the percentage of slope.
position to the next menu screen. The dots (A) at the top of the screen allow the user to see their screen position (highlighted dot) in the menu. Menu Screen 1 allows the user to mute or enable the audible alarm. The screen will display the current state of the alarm. Hold over the sensor for three seconds to change the setting. Menu Screen 2 changes the audible
Display Screen 3 displays the total slope angle in degrees, along with a visual horizon and roll indicator.
Display Screen 4 displays the total slope angle in degrees, along with independent front-to-back angle and side-to-side angle. Display Screen 5 displays the total slope angle in degrees, along with independent front-to-back angle and side-to-side angle with position indica- tors.
alarm set-point. Hold over the sensor until the set- point angle begins to flash. Swipe up across the sen - sor to cycle through the set-point options. Flashing
When the desired screen is reached, hold over the sensor to select and save. The slope gauge will re- member the selected screen when the power unit is shut off and will display the selected screen when the power unit is restarted.
When the desired set-point is reached, hold over the sensor to save the setting. Menu Screen 3 changes the visual alarm set-point. Hold over the sensor until the set-point angle begins to flash. Swipe up across the sensor to cycle through the set-point options. Flashing When the desired set-point is reached, hold over the sensor to save the setting. Menu Screen 4 calibrates the slope gauge. This zeros out the gauge at the current position. Refer to the slope gauge calibration section for calibration instruc- tions. Menu Screen 5 changes the screen display. There are five screen display options from which the operator can choose to display during operation. Hold over the sensor until the factory default screen is displayed. Swipe up to cycle through the display screen options.
Menu Screen 6 resets the slope gauge back to the factory default settings. The audible alarm will be turned on, and the audible and visual set-points will be restored to 20 de- grees. The slope gauge will need to be recalibrated before operating the power
unit. Hold over the sensor until the screen changes to show the default audible and visual alarm settings. Hold over the sensor again until the screen changes to notify you that the reset was successful. Menu Screen 7 exits the options menu. Hold over the sensor to exit and return to the display screen.
Operation - 41
Made with FlippingBook - Online Brochure Maker