Ventrac Operators Manual

SERVICE

Maintenance Schedule

Maintenance Schedule

Grease and Lubrication: Refer to the Lubrication Section

Front Hitch Lift Cylinder Center Pivot

2 1 ü 2 1 ü 1 1 ü 2 1 ü 2 1 ü 2 1 ü 2 1 ü 2 1 ü 2 # ü

üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü üüüüüüüüüüüüüüüüüüüü Engine !

Steering Cylinder

Drive Shaft

3 Point Cylinder (if equipped) 3 Point Hitch Pivot (if equipped)

Lower Connector Link

Seat Slide

Check the Engine Oil Level

ü

Change the Engine Oil and Filter ! Clean or Replace the Spark Plugs Inspect the Primary Air Filter Replace the Primary Air Filter

ü

üüüüüüüüüü

Consult the engine owner's manual*

ü

**

**

**

**

**

**

ü

ü ü

ü

ü ü

ü

Replace the Safety Air Filter Check the Coolant Level Service the Cooling System

ü

ü

Clean the Engine Compartment, Engine, and Radiator

**

ü

Replace the Fuel Filter

ü ü

ü

ü

Drain Water and Sediment from Fuel Tank

ü

Hydraulic System

Check the Hydraulic Oil Level Check the Rear Transaxle Oil Level Change the Hydraulic Filters %

ü

ü

ü ü ü

ü

ü ü

ü

ü ü

Change the Hydraulic Oil and the Rear Transaxle Oil

Parking Brake

Parking Brake Inspection and Adjustment

ü

Electrical

Clean the Battery Terminals and Compartment

ü

ü

Inspection

Inspect the Operator Interlock System Inspect the ROPS Structure and Seat Belt

ü ü ü ü ü ü

Inspect for Loose, Missing, or Worn Components Inspect the Battery, Electrical Connections, and Lights Inspect the Belts, Fuel Lines, and Hydraulic Lines

Check the Tire Pressure

Check the Wheel Lug Nuts. Torque to 75 Nm (55 ft-lbs)

üüüüüüüüüüüüüüüüüüüü

Check the Steering Cylinder Bolts. Torque to 203 Nm (150 ft-lbs)

üüüüüüüüüü

Check the Front/Rear Connector Link Bolts. Torque to 203 Nm (150 ft-lbs)

üüüüüüüüüü

Check the Front Hitch Pivot Bolts. Torque to 203 Nm (150 ft-lbs)

üüüüüüüüüü

*Follow service intervals for heavy loads and high temperatures. If unspecified, service at one-half the standard service interval. **Operation in severe conditions may require more frequent service intervals. ! Consult the Engine Owner's Manual for engine oil information and complete servicing information. # Silicon Based Spray Lubricant % Hydraulic filters initial change at 100 hours. Change the hydraulic oil and filters at 500 hours, then every 1,000 hours.

Service - 67

Made with FlippingBook - Online Brochure Maker