Toe Plates Aluminum plates simplify
Ride Height Set-Up Stick ALL10658 Stick replaces the coil over shock and spring assembly during maintenance. Stick has
setting of toe-in and toe-out. Plates fit against outside edges of tires. Using two tape measures (sold separately), measure the distance front and rear, between plates. The difference in tape readings is the toe setting. Deluxe plates have radiused
many uses and may be adjusted to check settings at normal ride height, in race attitude or on the bump
ALL10117
stops to evaluate suspension travel. Adjusts from 15" to 24", measured at the center of rod ends.
ALL10119
edges, slots for narrow and wide tape measures and are 9" tall x 23" wide to work with vehicles with smaller wheel openings. Standard plates are 1/2" thick, 11" tall x 32" wide and work well for vehicles with larger wheels and wheel openings. Set of two plates. ALL10117...... Standard ALL10119...... Deluxe 16' Tape Measure ALL10675
Set-Up Tool ALL10668 Tool replaces the front coil-over shock assembly to sim- ulate range of front suspension movement for checking bump steer and roll center. Hex head threaded shaft raises and lowers suspension to simulate racing condi- tions. Jam nuts can be positioned to limit rebound and compression. Not designed to support total vehicle weight, only suspension components. squaring and stringing chassis to ensure accu- rate chassis set-up by eliminating wheel and tire differences. Plates are 1/2" thick and can also be used when setting bump steer or checking axle tubes for straightness. Sold each. ALL10660 ..... 5x5, 7" x 28" ALL10662 ..... Wide 5, 12" x 28" Set-Up Stand set-up stand and adjust accordingly. Adjustments can be made with car at exact ride height with the wheel and tire out of the way. Sold each. ALL10664 ..... 5x5 ALL10666 ..... Wide 5 Upper Ball Joint Wrench ALL11190 Wrench is designed to remove and install common screw-in upper ball joints that are 1.900" wide (ALL56214). Adjustable Panhard Bar Wrench ALL11192 Wrench is designed to work with adjustable Panhard bars with 1-3/8" adjusters. Shorter than a standard wrench, this wrench is convenient for making adjustments in tight areas. ALL10660 ALL10662 Set-Up Plates Set-up plates are used for Before tire and wheel are removed, measure distance from center of hub to the ground. Remove the tire and wheel, replace with the
16' x 3/4" blade has fractional markings every 1/8" for quick reference. Caster Kit
Measure your front end caster by attaching an
NEW!
adapter and level holder to your upper ball joint threads. Additional adapters may be purchased separately for other use. Digital Level sold separately. ALL11162 ...... Kit with holder, BJ adapters and carry case (No Digital Level) ALL11164...... Holder Only for Digital Level ALL11165 ...... Quickchange Pinion Angle Adapters (2) ALL11166...... Late Model Spindle Adapter ALL10742...... 2x2 Digital Level Caster Plate ALL10752 Not sure if you turned your wheels the same amount each time when adjusting caster settings on your race car? Unless you have expensive turn plates, you’re never certain, until now. This quick reference gauge positions under the upper ball joint nut, with markings facing up, for easy viewing. Place a mark on the shock body or fabri- cate an indicator to use as a reference point.
Ground Clearance Indicator ALL10725 Determine how close the frame is to the ground on the race track. This unique kit features an aluminum bracket that rivets to the frame with an adjustable
4" plastic wear rod. Replacement Part ALL10726 ..... Wear Rods, 4-Pack
www.allstarperformance.com
246
Made with FlippingBook flipbook maker