Chassis Tie Down Brackets ALL60075 Steel brackets weld to chassis and provide a secure mounting location to hook a tie down strap or winch cable. Package of 2. Transmission Mount Bracket ALL38072 May be welded to chassis to support manual or automatic transmissions. Steel bracket is 1/8" thick with 1" x 7/16" slots for mounting bolts.
Ford 9" Truss Support ALL68330 Weld-on support adds strength to rear axle housing and reduces unwanted flex during extreme torque. Constructed of 12 gauge (.108") steel. 36" L x 2" W. Leaf Spring Pad ALL56126 Steel pad welds to 3" diameter rear end axle tube when mounting rear end to most leaf springs. Pad is 2-1/2" W by 5-3/4" L and has a 5/8" center pilot hole. Sold each.
Lower Spring Cups Steel spring cup has a 7" wide curved base that welds to the top of a 3" diameter rear end axle tube cre- racing springs. Commonly used to replace OE style “pigtail” lower spring mount. Sold each. ALL56124 ..... Standard Cup ALL56123 ..... Lightweight Cup NEW! Leaf Spring Slider Box ALL60034 ating a flat mounting surface for a 5" O.D.
Driveshaft Loop ALL69000 Universal
ALL56124
NEW Lightweight Version!
driveshaft loop contains the driveshaft if a yoke or U-joint fails. Loop is 1/4" thick x 2" wide mild steel and fully adjustable to fit most cars.
ALL56123
Driveshaft Loop For 1979-2004 Mustangs ALL69006
Driveshaft safety loop bolts-on to help retain the front of the
Leaf spring slider box replaces conventional leaf spring shackles to enable effortless suspension movement and prevent binding. Box may be welded, or bolted directly to chassis
driveshaft in the event of a U-joint or other drivetrain compo- nent breakage. Black epoxy coated, all steel loop includes mounting hardware and complete instructions. Loop is designed to fit inside factory tunnel and work with most driveshafts up to 4" in diameter.
and includes two nylon bushings with spring mounting hardware. Fits 2-1/2" wide Chrysler type leaf springs. Replacement Bushings ALL99055 Leaf Spring Slider Box ALL60035 Replace rear leaf spring shackles with Allstar’s leaf spring slider box. Bolt-in slider box with roller bearing design eliminates leaf spring binding, freeing up car. Fits 2-1/2" wide Chrysler type leaf springs.
Unwelded Driveshaft Loop ALL69004 Made from 3/16" flat steel, loop is 9-1/2" tall, 5-1/2" wide with a 16" wide mounting strap that can be cut and welded for each installation. 180° Driveshaft Loop ALL69002 Pre-bent 1" diameter x .083" wall mild steel tubing is designed for chassis style cars to help retain the driveshaft in the event of a U-joint failure. Loop is 10" tall overall and has a 5" I.D.
Adjustable Panhard Bar Mounting Bracket ALL60185
Bracket welds onto the rear of a 3" steel axle tube to mount a Panhard bar behind the axle housing. A machined 6" slot with a sliding retainer nut makes it possible to change roll center by adjusting Panhard bar angle with only one wrench. Bracket includes a 3" x 3/4"-10 bolt, two 5/16" wide spacers and a flat washer.
www.allstarperformance.com
55
Made with FlippingBook flipbook maker