S
S42 FOR SLIDING BUILT-IN DOORS
1
S
3
Assembly of upper and lower runners
2
1
3
Adjusting the upper runner with a wrench After fitting the door, use the enclosed plastic key to adjust the correct position of the door and tighten both screws. Secure the runner with the screws in the remaining holes.
Upper runner assembly Insert the runner and screw the 2 screws into the longitudinal holes of the runner, but do not tighten them completely
Lower runner assembly Install screws 1 and 2 Adjust the height Lock the runner 3 before fitting the door It is recommended to mount the lower runner 50 mm from the edge of the door (depending on the mounting profile), the mounting height of the runners depends on the height of the plinth and the size of the sash The upper runner is height-adjustable 4
4
Door assembly
Place the door in the upper rail, it is necessary to tilt the door from the bottom towards you
Lower the lower runner at the front door 7 mm lower
Lock the lower and upper runners in the correct position
5
Break assembly
6
Damper assembly
Damper assembly - see page 170
The brakes are finally installed after the door is fitted and adjusted
www.salu.cz
31
Made with FlippingBook - professional solution for displaying marketing and sales documents online