35
37,5
S50N FOR SLIDING BUILT-IN DOORS
1
2
Milling for lower and upper runners
ø 35
ø 35
55
12
15
60
Side handles can be used in the system: S04N, S08, 10N, S11N, S12, S13, S14, S19 a S24, S26FR.
12
15
60
17
55
12
30
12
60
55
35
ø 35
30
12
37,5
upper runner milling
35 lower runner milling
37,5
3
Installation of upper and lower runners and brakes
55
2
60
2
55
3
17
3
60
12
1
ø 35
1
17
12
Upper runner assembly Install screws 1 and 2 before installing the door Install screw 3 after fitting and adjusting the door
ø 35 Lower runner assembly Install screws 1 and 2 before installing the door Install screw 3 after fitting and adjusting the door
Softclose assembly (For aluminum frames, milling is only possible in profiles F1, G and J) The softclose activator is mounted in the upper profile for the front door, and mounted just behind the profile for the rear door
4
Door assembly
Place the door on the lower profile Lower the upper runner to the lowest position
Pull up the upper runner and define the door range
Lock the lower and upper runners in the correct position
USE OF FRAME PROFILES FOR FORGING
Damping can only be used for F1, G and J profiles. Overview and dimensions of the frames on page 164–187.
C
D
F1
G
J
K
M N
5
6
Stop and door brushes
Damper assembly
Vertical profiles can be supplemented with stop or door brushes, see page 162 for everything.
See page 171 for damper mounting.
www.salu.cz
35
Made with FlippingBook - professional solution for displaying marketing and sales documents online