Installation Simplicity ® Linear Plain Bearings
Straight Bore Housing – Slip Fit Bearing
3. Severe misalignment POSSIBLE SOLUTIONS for use with Standard “FL”: 1. Undersize the bearing O.D. (see chart) and install o-rings. 2. Oversize the housing I.D. (see chart) and install the standard bearing with o-rings. The additional clearance created by either method will allow the bearing to float in the housing and match the non-parallelism of the shafting. This solution is only for SEVERE cases that the standard self-aligning will not accommodate. The recommended method of retention for this mounting is a snap ring at each end. Accessories, including o-rings can be found on page 29 . Note: Do not use epoxy in this configuration. It will lock the bearing in place, not allowing it to self-align.
HOUSING
Additional Diametrical Clearance
O-rings act as a cushion allowing the bearing to float
MAX Additional Clearance
MAX Additional Clearance
MAX Additional Clearance
MAX Additional Clearance
MAX Additional Clearance
Part No.
Part No.
Part No.
Part No.
Part No.
in.
mm
mm
mm
mm
FJ06
0.203 0.203 0.203 0.203 0.203 0.203 0.254 0.254 0.305 0.305 0.305 0.305 0.305 0.406 0.406 0.508 0.610 0.610 0.610
FL03 FL04 FL06 FL08 FL10 FL12 FL16 FL20 FL24 FL32 FL40 FL48 FL64
0.0070 0.0080 0.0080 0.0080 0.0100 0.0100 0.0120 0.0120 0.0120 0.0120 0.0160 0.0160 0.0200
FM05 FM08 FM10 FM12 FM16 FM20 FM25 FM30 FM40 FM50 FM60 FM80
0.203 0.203 0.203 0.203 0.254 0.254 0.305 0.305 0.305 0.305 0.406 0.508
FMT06 FMT08 FMT10 FMT12 FMT14 FMT16 FMT20 FMT25 FMT30 FMT40 FMT50
0.203 0.203 0.203 0.203 0.203 0.254 0.254 0.254 0.305 0.305 0.305
FG06 FG08 FG10 FG12 FG15 FG16 FG18 FG20 FG25 FG30 FG35 FG40 FG50
0.203 0.203 0.203 0.203 0.254 0.254 0.254 0.254 0.305 0.305 0.305 0.305 0.305
FJH08
FJ08 FJ10 FJ12 FJ13 FJ16 FJ20 FJ25 FJ30 FJ35 FJ38 FJ40 FJ50 FJ60 FJ80
FJ100 FJ120 FJ150
150 Round Shaft Technology • pbclinear.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online