155
BRAKE SERVICE
#MV6830 • Compressed-air-operated unit offers professional grade brake and clutch bleeding performance. • This compact yet VACUUM BRAKE BLEEDER
#ATD5165 • For use on most domestic and import 2WD & 4WD vehicles • Use on front or rear brakes • Includes tools and adapters for both right- and left-handed applications • Use on main brake and parking brake systems • Prevents damage to brake piston and boot 18 Pc. Disc Caliper Tool Set
#720 • Tap Lightly with a Hammer and Turn Counterclockwise with a Tap Wrench to Remove the Screw • Features Undercut Flutes for More Positive Grip • Removes Broken Studs, Set Screws, Pipe and Alemite Fittings 5 Pc. Screw Extractor Set #4598 CATCH BAD BRAKE FLUID before it destroys calipers and other brake system components. Remove cap from brake fluid reservoir. 1. Press power button on top of tester. Green LED lights up. 2. Dip entire length of metal probes into brake fluid. 3. After one second, match color of LEDs with color chart to determine brake fluid quality. 4. Tester automatically powers off after 12 seconds of inactivity. Battery included. DOT 4 BRAKE FLUID TESTER
powerful unit bleeds up to 2
quarts (1.9 liters) per minute, and its simple operation allows clean, quick bleeding of brake and clutch lines.
#3762 • Zero setting at any position, Metric/Inch system • Interchange at any position, Data output interface, Data holding function • Fast tracing of minimum value or maximum value during measurements • Auto power on/off • Comes with deluxe on/off stand • Range 0-.500” (0-12.7mm) Dial Indicator Set • Kit includes an advanced selection of accessories that ensure maximum convenience and performance for greater productivity.
#CEN6450 • Range: 1” Graduations: .0011 Reading: 0-100 • Checks ball joint wear and disc rotor run-out. Rotor/Ball Joint GaUge • Checks gear backlash, valve guide wear and camshaft wear. • With optional attachments checks tire and wheel run-out. • Mounts directly on spindle. • Packaged in plastic blow-molded case.
#34550 • Quickly flushes out old grease and repacks bearings with less mess. • Works on bearings up to 3 1/2” O.D. • To pack a bearing, place the bearing on the piston. Press down on the cap until the old grease is forced out and the new grease shows on top of the bearing. BEARING PACKER
#82812 • Complete set of ratcheting T handle system of tap and die tools and 48 each taps and 48 each dies • Taps and dies made from top quality carbon tool steel • Blow molded case for safe and organized storage 114 piece Tap and Die Set
#82304 • Center Punch For Marking Center Lines and Pilot Drill Locations • Chisel For Cutting Rivets, Bolts, and Nuts • Pin Punch For Final Removal To Drive Out Pins and Rivets 5 Pc. Punch and Chisel Set
ORDER ONLINE: servicechamp.com | ORDER BY PHONE: 1.800.221.0216 | FOLLOW US:
Made with FlippingBook - Online magazine maker