Maintenance Inspection - Low Frequency Inspection Guide
Maintenance Inspection - Low Frequency Inspection Guide
Fasteners
Structural Members
This section applies to specific types of hardware and other fasteners and may not apply to all play components on the playground.
This section applies to the structural integrity of the playground and applies to all types of components.
1
2
3
1
2
This clamp is slipping.
This bolt is loose and should be tightened or replaced.
Hardware is missing and causing the component to come apart.
The cap is missing and should be replaced.
Worn ropes and an exposed anchoring device make this component unsafe.
4. Check that turnbuckles are fully engaged and properly adjusted. • Used to keep components such as climbing nets taut, turnbuckles may loosen over time.
1. Check that all hardware is present, tight, and fully engaged. • Physically check hardware to confirm that it is tight. Most manufacturers utilize self locking bolts or lock-tite, but intensive use of the equipment can cause bolts to loosen. If non-moving equipment moves, the hardware may be missing or not fully engaged. 2. Check that caps and plugs are present on the ends of all pipes and tubes. • Exposed tubing and pipe must have capped ends. Caps cover sharp edges, prevent insect infestation, and protect the metal from freeze cycles. The caps should be rounded, securely fastened, and should not create an entanglement or protrusion hazard. 3. Check that all fittings and bearings are functional, lubricated, and squeak free. • Fittings and bearings should be in good condition, not showing excessive signs of wear. Lubricate during inspection to prolong the life of the component. Replace fittings and bearings that are in poor condition, showing excessive signs of wear.
Springs require frequent lubrication.
• Adjust turnbuckle tension as required.
The concrete footing is exposed.
5. Check that all cables and ropes are securely fastened. • Cables and ropes must be securely anchored and not capable of looping back on themselves. Check to make certain that cables and ropes are in good condition and not unraveling or coming apart.
1. Check to make certain that all footings and other forms of anchoring devices are stable and are not exposed. • Concrete footings and other anchoring devices should be installed below the level of the protective surfacing material. If there are exposed footings, the play area should be taken out of service, and they should be corrected as soon as possible. 2. Check to make certain that structural members are sound and securely fastened. • Structural members, such as upright support posts, horizontal beams, and platforms, must be sound and securely fastened, fasteners being tight and secure, with no unintended
movement. When a component shifts, head entrapment hazards may be created. 3. Check that springs and rocking components are in good repair. • Coil springs and other types of rocking components are subject to heavy use. For this reason, they may crack or wear out and become loose from their anchoring devices. It is important to check the points of attachment to the footing and to the body of the spring rider. • Check the springs and rocking components for loose or missing hardware and for signs of cracking or degradation.
4
5
Preserving the Play Environment • Promoting the Value of Play • Protecting Children
Preserving the Play Environment • Promoting the Value of Play • Protecting Children
13
14
Made with FlippingBook Digital Publishing Software