STRATAFLEX Installation Guidelines for Curved surfaces
We suggest to apply the PVC after the substrates are bent and use a hair dryer or similar heat source to warm the PVC film when stretching it. 1. Apply primer to corners and 3D surface
2. Cut 100-150mm bigger than the actual size
3. Apply PVC to the flat surface first
4. Apply PVC to the curved surface
When you apply the PVC to the corner / 3D surface, you need to warm the PVC using a hair dryer to soften it. Once the PVC becomes soft enough, stretch gently toward you and apply to the curved surface. Press the PVC with a squeegee to avoid bubbles and wrinkles.
5. Remove unnecessary film by cutting
6. Where the PVC has been warmed and stretched, to prevent any possibility for this to peel off due to any shrinking, it is recommended to overlap another piece of PVC to protect it.
This gives complete cover by the PVC
77
Made with FlippingBook flipbook maker