Technical training
Blade Repair Standard / V5 23022026
ELEMENT 26.9 - INSPECTION AND DOCUMENTATION
Learning objective:
236) The participants can act independently in applying the knowledge gained in Lesson 22 (Blade Inspection) by practising the ability to inspect a blade surface and identify typical surface defects such as pinholes, scratches, and cracks (Ability, intermediate level)
The instructor shall:
Facilitate practice for the participants to apply the knowledge gained in Lesson 22 (Blade Inspection) by practising the ability to inspect a blade surface and identify typical surface defects such as pinholes, scratches and cracks Give constructive feedback on the participants’ application of the knowledge gained in Lesson 22 (Blade Inspection) by practising the ability to inspect a blade surface and identify typical surface defects such as pinholes, scratches and cracks
The participants shall:
Apply the knowledge gained in Lesson 22 (Blade Inspection) by practising the ability to inspect a blade surface and identify typical surface defects such as pinholes, scratches and cracks
LAMINATE REPAIRS
575 min.
The aim of the lesson is to enable the participants to actively remove damaged laminate, prepare for the repair and perform the repair safely and effectively.
After having successfully completed this lesson of the Blade Repair Module, the participants can:
237) Take responsibility for actively removing damaged laminate, preparing for the repair and performing the repair safely and effectively (Ability, intermediate level)
The participants should always refer to the safety data sheets, technical data sheets, work instructions and relevant applicable legislation throughout the duration of the repair conducted in this lesson
Note
The participants should always perform correct segregation and disposal of waste produced during this lesson
Note
Global Wind Organisation / www.globalwindsafety.org
120 / 187
Made with FlippingBook flipbook maker