Technical training
Blade Repair Standard / V5 23022026
Give constructive feedback on the participants’ application of the knowledge gained in Lesson 18 (Lamination Skills) by practising the ability to use a data logger to record and document the ambient temperature and humidity throughout the entire repair process
The participants shall:
Apply the knowledge gained in Lesson 18 (Lamination Skills) by practising the ability to use a data logger to record and document the ambient temperature and humidity throughout the entire repair process
FILLING, SHAPING AND FINISHING
180 min.
The aim of the lesson is to enable the participants to apply filling safely and effectively.
After having successfully completed this lesson of the Blade Repair Module, the participants can:
269) Take responsibility for applying filling safely and effectively (Ability, intermediate level)
The participants should always refer to the safety data sheets, technical data sheets, work instructions and relevant applicable legislation throughout the duration of the repair conducted in this lesson
Note
The participants should always perform correct segregation and disposal of waste produced during this lesson
Note
ELEMENT 28.1 - FILLER
Learning objectives:
270) The participants can locate areas in need of filling and apply filler material to gaps/pinholes in the laminate repairs previously conducted in Lesson 27 (Skills, intermediate level)
271) The participants can act independently in applying filler with the correct tools to fill pinholes and small defects in the surface of a wind turbine blade (Ability, intermediate level)
The instructor shall:
Global Wind Organisation / www.globalwindsafety.org
131 / 187
Made with FlippingBook flipbook maker