Technical training
Blade Repair Standard / V5 23022026
Demonstrate which tools to use and how to apply filler to fill small gaps and pinholes in the surface of a blade while maintaining the correct profile shape of the blade
Ask the participants relevant questions about the limitations of using filler in terms of short pot life and layer thickness
Facilitate practice to improve the participants’ ability to apply filler with the correct tools to fill pinholes and small defects in the surface of a wind turbine blade
Give constructive feedback on the participants’ above explanations and ability to apply filler with the correct tools to fill pinholes and small defects in the surface of a wind turbine blade
The participants shall:
Share their understanding of the limitations of using filler in terms of short pot life and layer thickness
TRAILING EDGE REPAIRS
380 min.
The aim of the lesson is to enable the participants to conduct a laminate repair on the trailing edge area of a wind turbine blade safely and in accordance with a work instruction.
Trailing edge repairs must be carried out in accordance with a blade manufacturer’s work instruction. Where these are not impossible to obtain, then the training provider shall create a work instruction
Note
After having successfully completed this lesson of the Blade Repair Module, the participants can:
272) Take responsibility for conducting a laminate repair on the trailing edge area of a wind turbine blade safely and in accordance with a work instruction (Ability, intermediate level)
The participants should always refer to the safety data sheets, technical data sheets, work instructions and relevant applicable legislation throughout the duration of the repair conducted in this lesson
Note
The participants should always perform correct segregation and disposal of waste produced during this lesson
Note
Global Wind Organisation / www.globalwindsafety.org
132 / 187
Made with FlippingBook flipbook maker